Assignment 6 MEC1012 SPR2005 Procedure for .stl (FDM model) 1. Create a model Make sure the wall thickness are a min of .07 (1.5mm) and max volume of 1”^3 2. Check the model iproperites for mass and volume. (check update if you have no info) Redesign your part to fit the volume requirements. (Perhaps make a derived part that is a scaled version of your original) 2. Make a .stl file using “file save as” Procedure for .dxf (CAM model) 1. Create sheet metal part 2. Make flat pattern (6”(y) x 10”(x) Max Size) 3. Make an .idw of the flat pattern. 4. “File save as” .dxf 5. Open .dxf file in Autocad; place & note the origin (see example next sheet) (You will have to “move” the pattern to it’s new origin) Retain ONLY the tool path and origin note 6. “Save as” Autocad R12 .dxf Establish & note the origin MAX 10” MAX 6” Flat Pattern File save as Autocad R12 .dxf