2D Engraving Process – Address Plate #2
1.
2.
3.
4.
Import the address plate DXF that was produced in Solidworks (same DXF used in Address Plate #1 Exe).
Check the Layout to insure that the part size is as drawn (X=10” Y=4.5”).
Check the Analysis to be sure that there are no duplicate shapes, sequence errors & direction errors.
Place all items with the exception of the material perimeter in the RED group.
5. Select “Special”, “Engrave 2D” and then set the dialogue box as shown below.
6. When setting the bit radius, ensure that the value is identical to the
actual bit being used at the router (selecting a different value will result in
undesired results). For this exercise we will be using a ¼” diameter straight
cutting flat bottomed bit (.125” radius). The various “Fill Types” are shown below.
“Island” is typically the most efficient type for our project work.
7. Once the 2D engrave features are set, select “OK” if the diagram appears as below, select “Enter”.
8. In the “Output” menu, set the “White”group “Machining Path” to “Off” and the “Depth” of the “Red” group to .125”.
9. Save the Ready File and make a test cut of the part.
10. BE SURE TO INSTALL A .25” DIAMETER STRAIGHT BIT ON THE ROUTER!