Uploaded by erabhi90.ce

Pages from Truss & RCC Beam DBR

advertisement
1
Introduction
The objective of this document is to present detailed design for checking adequacy of
Existing steel(metallic)/Concrete(non metallic) structure.
The structure is modelled on STAAD Pro Software.
2
Scope of the work
The scope of work in this project is to provide the design document for structural steel and
rcc portion i.e. Superstructure only.
3
Reference Codes and Standards
1
2
3
4
5
IS-800
Code of Practice for General Construction in Steel.
IS875 (Part1 to 3)
Code of practice for design loads (Other than
Earthquake) for buildings and structures.
IS 456
Code of Practice for Plain and Reinforced Concrete
(Fourth Revision)
Materials:1
Structural steel Plate Material
2
Rolled Section
3
Concrete
4
Reinforcement
IS2062
IS 800 & SP -6
Grade-25 N/mm2
Grade Fe-500 N/mm2
Design Philosophy & Assumptions
Following design philosophy & assumptions have been used for analysis & design of steel
and rcc structure.
1) The structure is modeled, analyzed through STAAD.Pro software.
2) Wind load is considered for structure design. Basic wind speed considered for analysis
= 47 m/s
Download