NZQA Expiring unit standard
22042 version 2
Page 1 of 3
Title
Perform advanced biochemical and/or microbiological tests in the
dairy industry
Level
4
Credits
6
Purpose
People credited with this unit standard are, for milk and/or other
dairy products, able to: explain and perform advanced
biochemical and/or microbiological tests; interpret and report
results of advanced biochemical and/or microbiological tests;
and troubleshoot abnormal test situations and results while
performing advanced biochemical and/or microbiological tests,
in the dairy industry.
Classification
Dairy Manufacturing > Dairy Laboratory Methodology
Available grade
Achieved
Entry information
Critical health and
safety prerequisites
Open.
Explanatory notes
1
Performance must be demonstrated and assessed in accordance with organisational
requirements.
2
Organisational requirements refers to instructions to staff on policy and procedures
(including the application of legislation to work site situations) which are formally
documented or generally accepted at the work site. . This may include legislation;
industry standards and methods; national and international standards and methods;
standards and methods published in internationally recognised reputable texts;
customer/organisation developed methods, standard operating procedures,
specifications, manuals, and manufacturer’s information.
3
The legislation and standards relevant to this unit standard may include but are not
limited to – Health and Safety in Employment Act 1992, Animal Products Act 1999;
Animal Products (Dairy) Regulations 2005; ISO/IEC 17025:1999 (NZS ISO/IEC)
General requirements for the competence of testing and calibration laboratories;
NZFSA-Approved Standards and Codes of Practice at
http://www.nzfsa.govt.nz/dairy/registers-lists.
4
Biochemical and microbiological tests include: inhibitory substances, phosphatase,
colostrums, RID plate, staining. Evidence for a minimum of two tests is required.
Primary Industry Training Organisation
SSB Code 101558
 New Zealand Qualifications Authority 2016
NZQA Expiring unit standard
22042 version 2
Page 2 of 3
Outcomes and evidence requirements
Outcome 1
Explain advanced biochemical and/or microbiological tests performed on milk and/or other
dairy products.
Evidence requirements
1.1
The principle of the test is explained in terms of technology, reactions and
processes involved.
1.2
Critical stages of the test are explained.
1.3
Variables of the test are explained and the process of eliminating variables is
described.
Range
1.4
may include but is not limited to – equipment, apparatus, reagents,
sample, technique, calibration, environment.
Quality assurance of the test is explained.
Range
may include but is not limited to – blanks, repeatability, duplicates,
reproducibility.
Outcome 2
Perform advanced biochemical and/or microbiological tests on milk and/or other dairy
products.
Evidence requirements
2.1
Samples and equipment are prepared.
2.2
Tests are performed according to process and procedures identified in
Element 1.
2.3
Tests are performed in a safe and aseptic manner.
2.4
Test results are confirmed.
2.5
Test equipment is cleaned and stored and samples and waste disposed of.
Outcome 3
Interpret and report results of advanced biochemical and/or microbiological tests on milk
and/or other dairy products.
Evidence requirements
3.1
Results are interpreted and reported accurately.
Primary Industry Training Organisation
SSB Code 101558
 New Zealand Qualifications Authority 2016
NZQA Expiring unit standard
3.2
22042 version 2
Page 3 of 3
Any non-conformance is identified and corrective action taken.
Outcome 4
Troubleshoot abnormal test situations and results.
Evidence requirements
4.1
Troubleshooting abnormal test situations identifies the nature of the problem,
uses effective problem solving techniques and reaches a valid solution.
4.2
Troubleshooting abnormal test results identifies the nature of the problem, uses
effective problem solving techniques and reaches a valid solution.
Replacement information
This unit standard has been replaced by unit standard
29130.
This unit standard is expiring. Assessment against the standard must take place by
the last date for assessment set out below.
Status information and last date for assessment for superseded versions
Process
Version Date
Last Date for Assessment
Registration
1
16 December 2005
31 December 2018
Review
2
17 September 2015
31 December 2018
Consent and Moderation Requirements (CMR) reference
0022
This CMR can be accessed at http://www.nzqa.govt.nz/framework/search/index.do.
Please note
Providers must be granted consent to assess against standards (accredited) by NZQA,
before they can report credits from assessment against unit standards or deliver courses
of study leading to that assessment.
Industry Training Organisations must be granted consent to assess against standards by
NZQA before they can register credits from assessment against unit standards.
Providers and Industry Training Organisations, which have been granted consent and
which are assessing against unit standards must engage with the moderation system that
applies to those standards.
Requirements for consent to assess and an outline of the moderation system that applies
to this standard are outlined in the Consent and Moderation Requirements (CMR). The
CMR also includes useful information about special requirements for organisations wishing
to develop education and training programmes, such as minimum qualifications for tutors
and assessors, and special resource requirements.
Primary Industry Training Organisation
SSB Code 101558
 New Zealand Qualifications Authority 2016