INSTALLATION INSTRUCTIONS V90041 REV A ACCURUS SQUARE INSULATED CEILING TRIM ACT953 BASED SERIES Page 1 of 2 Avoid Fire or Electric Shock THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. *Installation Instructions for qualified electricians only. *Install per National Electrical Code and local regulations. *Read Installation Instructions completely before installation. *Failure to follow Installation Instructions may void warranties. Hanger Bar Mounting (Residential): Joist Installation (Figure 3): 1. Adjustable hanger bars are preassembled with mounting bracket and provided with fixture.The preassembled hanger bars must attached to the fixture prior to installation.Align with two screws on end of fixture and tighten.Hanger bars are installed in Fig.1. Step 1 Extend bar hangers to fit between joist and position mounting tab locater lip tight to bottom of joist or framing member. Bar hangers should be level with bottom of joist or framing member.See Detail 3A. 2. Hanger bars can be used with grid ceilings having T bars and joist installations of wood.Adjustable hanger bars are for use in installations with spacing from 12" to 24", while maintaining minimum 1/2" spacing around fixture. Grid Ceiling Installation (Figure 2): Step 2 Attach bar hangers to joist or framing member using appropriate hardware for material. Step 3 Adjust housing platform position by sliding back and forth on bar hangers to desired position. Housing may be locked into position See Detail 3A.Nail Supplied in hanger bars will be suitable. Step 1 Extend bar hangers between the T bars and slide the slots in the mounting tabs over the T-bars. Step 2 Adjust housing platform position by sliding back and forth on bar hangers to desired position. Housing may be locked in the position by tightening bar hanger locking screws on housing platform.See Detail 2A. Optional "T" Screw Fixture Housing Cover Bracket Hanger Bar Figure 2 Detail 2A Safety Cable Trim Mechanism Adjustable Aperature Frame Detail 3A Figure 1 Figure 3 INSTALLATION INSTRUCTIONS V90041 REV A ACCURUS SQUARE INSULATED CEILING TRIM ACT953 BASED SERIES Page 2 of 2 Avoid Fire or Electric Shock *Installation Instructions for qualified electricians only. *Install per National Electrical Code and local regulations. *Read Installation Instructions completely before installation. *Failure to follow Installation Instructions may void warranties. Adjustable Aperture Ring Rotational Adjustment Ring Lock Knob Fixture Ceiling Caulk Adjustable Aperture Ring Retainer Clip Trim Mechanism Figure 4 3. Install Ceiling drywall up to Adjustable Frame on Fixture See Fig. 4. 4. Position Adjustable Frame to be in plane with Ceiling by sliding up or down.See Fig.4 5. Apply caulking or mudding compound around perimeter edge of Adjustable Aperature Ring and drywall cutout. Trim Installation: 6. Connect Safety Cable attached to Trim to Fixture by inserting Safety Cable through opening in Fixture and inserting Snap Hook (See Fig. 1) on end of Safety Cable into hole in Bracket attached to inside of fixture. 7. Install Trim Mechanism into fixture by pressing firmly to engage retainer Clips.See Fig.4. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.