INSTALLATION INSTRUCTIONS
V90185 REV A
MINI ACCURUS INSULATED CEILING SQUARE
TRIM ACM512 BASED SERIES
Page 1 of 2
Avoid Fire or Electric Shock
THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
*Installation Instructions for qualified electricians only.
*Install per National Electrical Code and local regulations.
*Read Installation Instructions completely before installation.
*Failure to follow Installation Instructions may void warranties.
Hanger Bar Mounting (Residential):
Joist Installation (Figure 3):
1.
Adjustable hanger bars are preassembled with mounting
bracket and provided with fixture.The preassembled hanger
bars must attached to the fixture prior to installation.Align with
two screws on end of fixture and tighten.Hanger bars are
installed in Fig.1.
Step 1 Extend bar hangers to fit between joist and position
mounting tab locater lip tight to bottom of joist or framing
member. Bar hangers should be level with bottom of joist
or framing member.See Detail 3A.
2.
Hanger bars can be used with grid ceilings having T
bars and joist installations of wood.Adjustable hanger
bars are for use in installations with spacing from 12" to 24",
while maintaining minimum 1/2" spacing around fixture.
Grid Ceiling Installation (Figure 2):
Step 2 Attach bar hangers to joist or framing member using
appropriate hardware for material.
Step 3 Adjust housing platform position by sliding back and
forth on bar hangers to desired position. Housing may be locked
into position See Detail 3A.Nail Supplied in hanger bars will be
suitable.
Step 1 Extend bar hangers between the T bars and slide the slots
in the mounting tabs over the T-bars.
Step 2 Adjust housing platform position by sliding back and
forth on bar hangers to desired position. Housing may be locked
in the position by tightening bar hanger locking screws on
housing platform.See Detail 2A.
Optional
"T"
Screw
Fixture Housing Cover
Bracket
Hanger Bar
Figure 2
Detail 2A
Safety Cable
Trim Mechanism
Adjustable
Aperature Frame
Detail 3A
Figure 1
Figure 3
INSTALLATION INSTRUCTIONS
V90185 REV A
MINI ACCURUS INSULATED CEILING SQUARE
TRIM ACM512 BASED SERIES
Page 2 of 2
Avoid Fire or Electric Shock
*Installation Instructions for qualified electricians only.
*Install per National Electrical Code and local regulations.
*Read Installation Instructions completely before installation.
*Failure to follow Installation Instructions may void warranties.
Adjustable Aperture Ring
Rotational Adjustment Ring
Lock Knob
Fixture
Ceiling
Chaulk
Adjustable Aperture Ring
Ball Catch
Trim Mechanism
Figure 4
3.
Install Ceiling drywall up to Adjustable Frame on Fixture
See Fig. 4.
4.
Position Adjustable Frame to be in plane with Ceiling by
sliding up or down.See Fig.4
5.
Apply caulking or mudding compound around perimeter edge of
Adjustable Aperature Ring and drywall cutout.
Trim Installation:
6.
Connect Safety Cable attached to Trim to Fixture by inserting Safety
Cable through opening in Fixture and inserting Snap Hook
(See Fig. 1) on end of Safety Cable into hole in Bracket attached to
inside of fixture.
7.
Install Trim Mechanism into fixture by pressing firmly to retain Ball
Detent Catches.See Fig.4.
THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.