QUICK SPEC
SMOOTH & GRANULATED ASPHALTIC – ROOF MATE
NOTE: The following “Quick Spec” is an abbreviated specification and is not meant to replace the detailed specification. Read
the entire 3-Part CSI System Specification prior to starting the project.
Method

Spray, roller, or brush
Requirements




Moisture survey recommended.
Roof must be clean, dry, and tight.
Adhesion test required to ensure proper adhesion to substrate(s).
Apply at 50°F (10°C) and rising with no rain or freezing temperatures in forecast for 24 hours.
Application
Instructions
1.
2.
Conduct moisture survey and remove/replace all wet areas.
Repair membrane including seams, penetrations, flashings, curbs, and terminations with like
materials.
Power-wash roof. It is recommended to use United Cleaning Concentrate (UCC) to clean the
roof. Allow roof to completely dry.
Treat all roof penetrations, drains, curbs, and scuppers.
Treat any loose seams.
Treat “alligatored” areas or surface cracks.
Apply coating per the chart below:
3.
4.
5.
6.
7.
SMOOTH & GRANULATED ASPHALTIC SPECIFICATION ROOF MATE Base Coat
Coating
Product Primer
(Gal/Sq)
UniBase
1.00
UniBase
1.00
10 Year
UniBase
1.00
UniBase
1.00
15 Year
Product (Choose one)
Roof Mate
Roof Mate QS
Roof Mate HT Roof Mate
Roof Mate QS
Roof Mate HT 1st Coat
2nd Coat
1.50
Warranty
3rd Coat
Coating
(Gal/Sq)
Limited Warranty
Emerald Pledge
Diamond Pledge
1.50
3.00
Yes
Yes
No
1.50
1.50
3.00
Yes
Yes
No
1.50
1.50
1.50
4.50
Yes
Yes
No
1.50
1.50
1.50
4.50
Yes
Yes
No
* Dry Film Thickness (DFT) includes Base Coat, uses the average % solids by volume between the two coatings, is rounded to nearest mil, and is theoretical. Actual DFT will vary dependent on substrate profile, application technique & waste factor.