EverGuard EZ Fascia
ORDER / SPECIFICATION FORM
(For Single-Ply Membrane)
FASCIA FORMED
IN 10'-0" LENGTHS
2 1/4"
MEMBRANE 2
BY OTHERS
SEALANT BY
INSTALLER
3/4"
90°
#9 x 1-1/2" SS SCREW
w/ WASHER, PROVIDED
COVERAGE
FACE
BLOCKING
BY OTHERS
1
CONCEALED JOINT
SPLICE, 4" WIDE
20GA GALV RETAINER
FORMED IN 10'-0" LENGTHS
#9 x 1-1/2" SS SCREW w/ WASHER,
PROVIDED FOR FACES 6" OR GREATER
(CONTACT MANUFACTURER IF FASTENER
WILL FALL ON BRICK/MASONRY)
7/8"
1/2"
Face = Coverage (should extend a min. of 1" below water resistant wall surface)+1 5/8".
2 Coordinate installation with membrane manufacturer.
QUANTITY
-
Total LF (10'-0" pcs)
Miters (___ Outside, ___ Inside)
MATERIAL
THICKNESS
ACCESSORY TYPE
FINISH
End Caps (___ Left, ___ Right)
Mill Finish
Folded
0.040
Aluminum
End Terms (___ Left, ___ Right)
0.050
Prefinished Kynar
Galvanized
Radius LF (Notched - 10'-0" pcs)
0.063
Post Finished Kynar
Stainless Steel
Vaulted LF (Welded - 5'-0" pcs)
Prefinished Anodize
24GA
Sumps
Post Finished Anodize
22GA
MODEL
Spill Outs
375
Special Corners
525
(Attach Sketches)
COLOR
675
®
0.063 prefinished Kynar is only available in Statuary Bronze, Medium Bronze, Sandstone, Dove Gray, Ascot White, Forest Green & Bone White
LA
S SI F I E
UL
D
ANSI/SPRI
ES-1 TESTED
(Contact manufacturer for verification of test
report data on your project)
C
APPROVALS
®
CUSTOMER APPROVAL
Approved for Fabrication
Approved with Changes Authorized Customer Signature
Disapproved, Resubmit
Title
R27207
Date
Job Name:
Customer:
By:
Job #:
Representative:
Date:
Architect:
Sheet
Location:
Rev. 12/15
1 Campus Drive - Parsippany, NJ 07054 - Phone: (877) GAF-ROOF / (877) 423-7663
www.gaf.com
of
EverGuard EZ Fascia
Fascia
Model
Nailer Retainer
Face
Height Coverage Gauge
375
3 3/4"
2 1/8"
20GA
525
5 1/4"
3 5/8"
20GA
675
6 3/4"
5 1/8"
20GA
MIN
3 3/4"
2 1/8"
20GA
MAX
12 3/4"
11 1/8"
20GA
1/4"
GAP
FASCIA
CONCEALED
JOINT SPLICE
20GA RETAINER
MEMBRANE
BY OTHERS
SEE NOTE
BELOW
24"
OUTSIDE MITER
END CAP
30"
11"
7"
LEFT HAND SHOWN
SUMP
2 PIECE ASSEMBLY
SEE NOTE
BELOW
SEE NOTE
BELOW
24"
29"
INSIDE MITER
END TERM
2 PIECE ASSEMBLY
RIGHT HAND SHOWN
5"
SPILLOUT
Standard fascia miter leg lengths: 12" nominal
Standard fascia miter angle is 90°
For special miter requirements, attach sketches or consult manufacturer for assistance.
Rev. 12/15
3 PIECE ASSEMBLY