GAF Traditional Gutter
ORDER / SPECIFICATION FORM
GUTTER FORMED
IN 10'-0" LENGTHS
CONCEALED JOINT
SPLICE, 6" WIDE
MEMBRANE
1
BY OTHERS
FLANGE
(OPTIONAL)
GUTTER STRAPS,
1" WIDE @ 30" OC
POP-RIVETS,
PROVIDED
5/8"
1"
1 1/4"
BLOCKING
BY OTHERS
FASTENERS
BY INSTALLER
BACK 3
FACE
GUTTER HANGERS,
0.250 ALUM, 1" WIDE
@ 30" OC (OPTIONAL)
BOTTOM 2
1 Coordinate installation with membrane manufacturer.
2 Bottom dimension must be > than face dimension.
3 Back dimension must be 1" (min) larger than face dimension.
MATERIAL
THICKNESS
0.040
Aluminum
Total LF (10'-0" pcs)
0.050
Galvanized
Miters (___ Outside, ___ Inside)
0.063
Stainless
Steel
End Caps (___ Left, ___ Right)
0.080
Expansion Joints (If Required)
0.125
Compound Miter (Attach Sketches)
24GA
Radius LF (5'-0" pcs)
22GA
QUANTITY
ACCESSORY TYPE
Welded
HANGERS
Yes
FINISH
Mill Finish
Prefinished Kynar
Post Finished Kynar
Prefinished Anodize
Post Finished Anodize
COLOR
0.063 prefinished Kynar is only available in Statuary Bronze, Medium Bronze, Sandstone, Dove Gray, Ascot White, Forest Green & Bone White
®
APPROVALS
(Contact manufacturer for verification of test
report data on your project)
CUSTOMER APPROVAL
Approved for Fabrication
Approved with Changes Authorized Customer Signature
Disapproved, Resubmit
Title
Date
Job Name:
Customer:
By:
Job #:
Representative:
Date:
Architect:
Sheet
Location:
Rev. 12/15
1 Campus Drive - Parsippany, NJ 07054 - Phone: (877) GAF-ROOF / (877) 423-7663
www.gaf.com
of
GAF Traditional Gutter
Face
Bottom
Back
Minimum
4"
4"
5"
Flange
(Optional)
1"
Standard
-
-
-
4"
Maximum
12"
14"
16"
6"
1/4"
GAP
CONCEALED
JOINT SPLICE
GUTTER
STRAPS
MEMBRANE
BY OTHERS
HANGERS
(OPTIONAL)
SEE NOTE
BELOW
SEE NOTE
BELOW
2'-0"
END CAP
OUTSIDE MITER
RIGHT HAND SHOWN
2'-0"
SEE NOTE
BELOW
SEE NOTE
BELOW
2'-0"
INSIDE MITER
Standard gutter miter leg lengths: 24" nominal
Standard gutter miter angle is 90°
For special miter requirements, attach sketches or consult manufacturer for assistance.
Rev. 12/15
EXPANSION JOINT
(IF REQUIRED)