LIEBERT® SITEIP-E™ Product Specification/Installation Sheet Description The Liebert SiteIP-E is an Ethernetready device intended to interface specifically to a Liebert SiteScan® Web System. The unit is a 32-bit microprocessorbased device designed to monitor power and cooling systems via open protocols over an Ethernet network. Logically the device sits within the Ethernet subnet of the power and cooling systems, providing the interface to Liebert SiteScan Web. This effectively creates a general purpose Ethernet protocol converter. Module Dimensions and Layout 0.230" (5.8mm) 11.295" (286.89mm) Without Keypad Display 24Vac, 24VA, 1A, 50-60 Hz 26Vdc, 10 W, 0.4A Use Copper Conductors Only Class 2 1.25" (31.8mm) Ground 3V Lithium Battery CR-123 A 10/100 Base T Ethernet Port E1 24V AC/DC Power On 100 LAN 2.5" (63.5mm) 7.5" (190.5mm) 2.5" (63.5mm) SiteIP-E Ext. Batt. Int. Batt. SSW-IPE Gnd Rnet + Rnet +12V Sense Local Access Gnd Rnet + Rnet Rnet +12V Error Codes 0 = Download Required 1 = Control Program Error Archive Valid Brownout Low Battery 1.25" (31.8mm) Off External Gnd Battery +3V LINK EnhancedAccess on Rnet Module Status Default IPAddress IPAddress Assigned On 2 = RAM Full 3 = Comm Setup Error 4 = System Error 8 = Formatting Off +100 Default 1 0 2 3 Chase = OK Blinking Dot = 'Run' Open Energy Management Equipment 1 2 3 4 5 6 7 8 Power LED Format Module Address (IP) 10's 1's R 88FO E143900 TYPE: 002001 1 Made in US A 0.230" (5.8mm) Enclosure Mounting The enclosure may be mounted on a wall or on the floor. Refer to the following diagrams for your application. Enclosure Mounting Diagrams 0.88" (22.2mm) 0.88" (22.2mm) 12.5" (317.5mm) 1" (25.4mm) 1" (25.4mm) A 11" (279.4mm) 11" (279.4mm) 1" (25.4mm) 1" (25.4mm) 0.88" (22.2mm) 12.5" (317.5mm) R 0.107" (2.71mm) 0.4" (10.2mm) DETAIL A 2 R 0.188" (4.76mm) 0.88" (22.2mm) Enclosure Mounting Diagrams (continued) 14.25" (362mm) 12" (304.8mm) 1.13" (28.6mm) 3.35" (85mm) 3.92" (99.6mm) B 1.15" (29.3mm) 1.25" (31.8mm) 1.5" 1.5" (38.1mm) 1.5" (38.1mm) (38.1mm) 5.88" (149.2mm) 5.25" (133.4mm) 2.5" (63.5mm) 0.88" (22.2mm) DETAIL B 1.5" 1.5" (38.1mm) 1.5" (38.1mm) (38.1mm) 5.88" (149.2mm) 3 0.6" (15.1mm) Specifications Power 24VAC ±10%, 50 to 60Hz, 24VA, or 26VDC ±10%, 10W Module: Enclosure (charcoal): 11.3 x 0.56 x 7.5 (287 x 14.2 x 190.5) 14.25 x 2.85 x 12 (362 x 72.4 x 304.8) Dimensions W x D x H: in. (mm) • One (1) Ethernet 10/100BaseT RJ-45 port • Rnet: Local laptop and/or BACview access port. Conforms to the BACnet Advanced Application Controller (B-AAC) Standard Device as defined in BACnet 135-2001 Annex L. 20°F to 140°F (-29°C to 60°C); 10 to 90% relative humidity, non-condensing. Note: Control modules should be installed within the building. 16 MByte non-volatile battery-backed SDRAM (with 12 MBytes available for use) 8 MByte Flash memory, 32-bit memory bus Built-in surge and transient protection circuitry 3V lithium battery P/N CR-123A; battery shelf life is 10 years with 720 hours of continuous operation Hardware watchdog timer UL916 (Canadian Std C22.2 No. 205-M1983), CE, FCC Part 15 - Subpart B - Class A Communication Environmental Operating Range Memory Protection Battery Fault Detection Agency Listings Diagnostic LEDs Indicator Description Indicator Description Archive Valid Blinks when data is transmitted Blinks when data is received N/A Port S1 transmit Port S1 receive Battery low Blinks when data is transmitted Blinks when data is received Blinks when the battery is low Wiring Specifications Connection Ethernet 10 BaseT Supported Wire Types CAT 5 Maximum Wire Length Rating 328 ft. (100m) N/A Ordering Information Quantity Part # Description SSW-IP-E SSW-IPEWO SiteScan Web Ethernet Open Protocol Converter to BACnet Module SiteScan Web Ethernet Open Protocol Converter to BACnet Module Without Enclosure Liebert Corporation 1050 Dearborn Drive P.O. Box 29186 Columbus, OH 43229 Telephone: 1-800-877-9222 Facsimile: 1-614-841-6022 www.liebert.com © 2009 Liebert Corporation All rights reserved throughout the world. Specifications subject to change without notice. ® Liebert and the Liebert logo are registered trademarks of Liebert Corporation. All names referred to are trademarks or registered trademarks of their respective owners. SL-28079 (7/09) Rev. 0 4