Introduction to ECE 1201

advertisement
ECE 1201
Engineering Lab II
•
•
•
•
•
Taaruf
Nor Farahidah Za’bah
Room number : E2-2-13.12
Phone number : 03-61964562
Email address : adah510@iium.edu.my
The lab technicians are
– Br. Shahbudin Basri and Br. Rosley Mahadi
• Course website:
• http://staff.iium.edu.my/adah510
Tentative Week
Experiment No. (Title)
1
2
3
Introductory class – Briefing on the organization of the course
Introduction to PSPICE
PSPICE
Experiment No. 1 & 2
4
(Diode Characteristics & Zener Diode Characteristics)
Experiment No. 3
5&6
(Wave Rectifier & Clipper Circuit)
Experiment No. 4
7&8
(BJT Characteristics & Common-Emitter Transistor Amplifier)
Experiment No. 5
9 & 10
(BJT Biasing Circuits)
Experiment No. 6
11
(MOSFET - Common Source Amplifier)
Experiment no. 7
12
(Inverting and Non-Inverting OP Amp)
Assessment
Quiz
20 %
Final Test
35 %
Lab Report
45 %
Safety
• Please wear covered shoes – NO SLIPPER.
Otherwise, you will be asked to leave the lab.
• Power must be switched off whenever an
experiment or project is being assembled,
disassembled, or modified.
Tidiness
• When the experiment has been satisfactory
completed and the results approved by the
instructor, the students may disconnect the
circuit and return the components and
instruments to the locker tidily.
• Chairs are to be slid in properly.
• DO NOT WRITE anything on the table
Preparation
• Read the entire experiment and research any
required theory beforehand. Many times an
experiment takes longer that one class period
simply because a student is not well prepared.
• The experiment is performed in pairs (max=3
students per group) but the final exam is
performed individually
– One group = one lab report
Lab Reports
• Reports have to be handwritten for
submission.
– Writing should appear on one side of each sheet
only.
– The students’ name & matric number, section
number, lab session and the lecturer’s
– Please indicate the author of each section in your
report.
• The cover page of the lab report can be
downloaded from the website.
Report Format and Evaluation
No.
Evaluation Items
% Marks
1
Objectives
2
2
Experiment Set-up
4
3 Results & Observation
4
4
PSPICE
4
Discussion and
5
6
Conclusion
TOTAL
20
Preparation for PSPICE Tutorial
Tentative Week
Experiment No. (Title)
1
2
3
Introductory class – Briefing on the organization of the course
Introduction to PSPICE – Tutorial 1
PSPICE - Tutorial 2
Preparation for PSPICE Tutorial
• Download 16.6_OrCAD_Lite_Capture&PSpice_Products.zip
from the any computer in the lab
– It is a zipped file, you have to extract the files into a
designated folder
– Once you have extracted, go to Disk 1 and look for
SETUP (it is an application file) to install the
software.
– One group will require ONE laptop for the tutorial
sessions
Introduction to Lab Equipment
• Bread board and its connections
• Function Generator
– To create AC signals such as Sine-Wave, Triangular
Waves and Square Wave
– The user can alter its frequency and amplitude
Example of
a function
generator
• Oscilloscope
– An equipment to show the obtained result.
– Has 2 channels
• One for input signal
• One for output signal
• DC power supply
– To provide DC supply to your circuit which you can
measure using digital multimeter
Download