Guardian Protective Coatings Pty Ltd
PO Box 3337 Nedlands 6909
2/44 Barnfield Road, Claremont, 6010
Tel: +61 (0)8 6389 2100
Fax: +61 (0)8 92846660
Email:gary@guardit.net
A.C.N. 061 748 543
PRODUCT INFORMATION SHEET
PRODUCT:
GUARDIAN GRAFFITI REMOVER
Product Code: GGRPI
Issue Date: JANUARY 2015
Page 1 of 1
Description
An environmentally safe, biodegradable, non caustic cleaner for the removal of most spray enamels, acrylics, permanent
markers, crayons and lipstick off surfaces protected with Guardian Anti Graffiti Coating. May also be used on ceramic
tiles, stainless steel, porcelain and formica.
Prior to use on other coatings, test for compatibility as damage may occur.
Application
STEP 1 Ensure the surface to be cleaned and cleaning utensils are completely dry prior to application of remover.
STEP 2 Apply remover to graffiti by brush or atomiser and work into graffiti using a stiff bristle brush in a circular motion.
Leave remover to work for 3-5 mins.
STEP 3 Commence removal at base of graffiti and work on small areas at a time. Remove each section as you go
with a sponge and water or damp cloth.
STEP 4 Stubborn stains or old graffiti may require multiple applications. Wipe the surface dry between applications.
* If ghosting occurs ensure that the surface is dry and repeat steps 2-3
* On smooth surfaces wash graffiti off with water and a clean cloth.
* On rough surfaces, wash graffiti off with water and a natural bristle brush or high pressure clean.
*Apply to colorbond and reflective signs with a small brush and agitate until graffiti is dissolved (max 15-30sec) wash graffiti
off with water and a clean cloth.
Specification Sheets: Before application refer to the corresponding Material Safety Data Sheets GGRMSDS.
Thinning :Do not thin
Wash Up:Water
Shelf Life: 18 months in closed containers
Safety Precautions
*Keep out of reach of children.
*Avoid contact with eyes, wear safety goggles.
*Avoid contact with skin, wear chemical resistant gloves.
*Avoid vapour (or) spray mist, ensure adequate ventilation.
*Do not smoke. Store in a safe, dry place away from direct heat or any source of ignition.
*Keep unwanted product in sealed containers for disposal via special waste collection.
First Aid
*If poisoning occurs, contact a doctor or Poisons Information Centre.
*If swallowed, do not induce vomiting, give plenty of water and seek medical advise
*If skin contact occurs, remove contaminated clothing and wash skin thoroughly with soap and water.
*If overcome by fumes, move to fresh air and if condition persists seek medical advise.
*If in eyes, hold eyes open, flood with water for at least 15 minutes and seek medical advise.
The statements above are compiled from our field of production and according to the latest technological developments and application techniques.
Since application and working are beyond our control, no liability of the producer can be derived from the contents of this information sheet.
Guardian Protective Coatings Pty Ltd and associated group of companies shall not be responsible for any damage or injury resulting from abnormal
use of the material, from any failure to adhere or observe the recommendations, or from any hazards inherent in the nature of the material. It is the
users responsibility to evaluate the information contained herein and use this product safely and within the current laws and regulations.
Prodinfo..doc
Guardian Protective Coatings Pty Ltd
PO Box 3337 Nedlands 6909
2/44 Barnfield Road, Claremont, 6010
Tel: +61 (0)8 6389 2100
Fax: +61 (0)8 92846660
Email:gary@guardit.net
A.C.N. 061 748 543
MATERIAL SAFETY DATA SHEETS
PRODUCT:
GUARDIAN GRAFFITI REMOVER
Product Code: GGRMSDS
Issue Date: JANUARY 2015
Page No: 1 of 3
Worksafe Hazard Assessment: Hazardous According To Criteria Of Worksafe Australia
Company details:
Guardian Protective Coatings Pty Ltd
2/44 Barnfield Road
Claremont Western Australia 6010
TEL:+61 86 389 2100
FAX:+61 8 9284 6660
UN: Transport is not regulated
SUB RISK: None allocated
EPG: None allocated
POISON SCHEDULE: Not scheduled
CLASS: Combustible Class C1 (AS1940)
HAZ CHEM CODE: None allocated
PACKAGING GROUP: None allocated
USES: Cleaner for the removal of graffiti.
PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: Clear light blue liquid with a citrus odour
BOILING POINT: >150C
VAPOUR PRESSURE: No data available
SPECIFIC GRAVITY: 1.02g/lt
FLASH POINT: 64 C
% VOLATILES: No data available
INGREDIENTS
Chemical Name
Esters
n-Methyl pyrrolidone
Surfactants
Terpene
MELTING POINT: <0C
VAPOUR DENSITY: >1
SOLUBILITY (WATER): Emulsifiable
EXPLOSION LIMITS: No data available
pH: 3.0-4.0
CAS Number
872-50-4
Proportion
30-60%
10-30%
0-10%
10-30%
HEALTH HAZARD INFORMATION
INGESTION:
Ingestion may cause irritation to the stomach, nausea and vomiting. If vomiting occurs after ingestion, small droplets of
the liquid may enter the lungs (aspiration) with the risk of chemical pneumonia being induced.
EYE:
Irritating.
SKIN
Mildly irritating. Contact with the product may defat the skin and contribute to dermatitis.
INHALATION:
Product has very low volatility and does not evaporate readily. However, if generated, vapours or spray mists are irritating
to the eyes, nose, throat, mucous membrane, and respiratory tract and have anaesthetic properties. Inhalation may cause
headache, nausea and dizziness.
msds.doc
Guardian Protective Coatings Pty Ltd
PO Box 3337 Nedlands 6909
2/44 Barnfield Road, Claremont, 6010
Tel: +61 (0)8 6389 2100
Fax: +61 (0)8 92846660
Email:gary@guardit.net
A.C.N. 061 748 543
MATERIAL SAFETY DATA SHEETS
PRODUCT:
GUARDIAN GRAFFITI REMOVER
Product Code: GGRMSDS
Issue Date: JANUARY 2015
Page No: 2 of 3
CHRONIC
No information available at present. Inhalation and ingestion are the routes of entry into the body. The product defats the
skin and prolonged or repeated contact may contribute to dermatitis.
TOXICITY DATA
n-Methyl pyrrolidone
LD50 (oral, rat): 3914mg/Kg
LD50 (skin, rabbit): 8g/Kg
FIRST AID PROCEDURES
INGESTION
NEVER GIVE AN UNCONSCIOUS PERSON ANYTHING TO DRINK NOR ATTEMPT TO INDUCE VOMITING.
If person is conscious, rinse mouth out with water ensuring that mouth wash is not swallowed. Give about 250ml (2
glasses) of water to drink. DO NOT attempt to induce vomiting. Seek medical attention.
EYE
Hold eyelids open and rinse the eye continuously with a gentle stream of clean running water for at least fifteen minutes.
Seek medical attention.
SKIN
Remove contaminated clothing and wash thoroughly with soap and water. Use water alone, if soap is unavailable. Apply
a moisturising hand cream, if available. Seek medical attention if any soreness or inflammation of the skin persists or
develops later. Launder affected clothing before re-use.
INHALATION
Remove to fresh air. Keep warm and at rest. If breathing is laboured, hold in a half upright position (this assists
respiration). Apply artificial respiration if breathing has stopped. Seek medical attention.
PRECAUTIONS OF USE
ENGINEERING CONTROL
There are no special requirements for use outdoors or in well ventilated areas. If the product is used in poorly ventilated
areas then fan forced air ventilation may be required.
PERSONAL PROTECTION
Safety glasses with side shields or safety goggles, PVC or natural rubber gloves and overalls. Respiratory protection is
unlikely to be required for normal use but if inhalation risk exists wear an organic vapour/particulate respirator complying
to the requirements of AS/NZS 1715 and AS/NZS 1716.
N.B. TAKE THE LIMITS OF ABSORPTION CAPACITY INTO ACCOUNT. CHANGE FILTERS REGULARLY.
AIR PURIFYING RESPIRATORS DO NOT PROTECT AGAINST OXYGEN DEFICIENT ATMOSPHERES
msds.doc
Guardian Protective Coatings Pty Ltd
PO Box 3337 Nedlands 6909
2/44 Barnfield Road, Claremont, 6010
Tel: +61 (0)8 6389 2100
Fax: +61 (0)8 92846660
Email:gary@guardit.net
A.C.N. 061 748 543
MATERIAL SAFETY DATA SHEETS
PRODUCT:
GUARDIAN GRAFFITI REMOVER
Product Code: GGRMSDS
Issue Date: JANUARY 2015
Page No: 3 of 3
FLAMMABILITY
Combustible. If the product is heated, vapours can form flammable mixtures with air in poorly ventilated conditions. May
evolve toxic fumes if heated strongly or burned. The product may react with strong oxidising agents such as liquid or
powdered chlorine.
EXPOSURE STANDARD
No exposure standards have been established for this product or its components.
SAFE HANDLING PROCEDURES
STORAGE TRANSPORT
Transport is not regulated. Store out of direct sunlight in a cool well ventilated area below 25C. Higher temperatures may
cause pressure build up inside containers. Segregate from oxidising agents and acids. Protect containers against physical
damage.
RISK PHRASES
R36: Irritating to Eyes
R38: Irritating to Skin
PACK SIZE
250 ml & 750ml Trigger Packs, 5lt or 10lt Plastic Containers
SPILLS DISPOSAL
SPILLS: Ensure that there are no sources of ignition present. Remove unnecessary personnel from the affected area.
Wear protective equipment as specified for handling. If possible, dam the spill. Cover with an absorbent such as earth,
sand or a commercial oil absorber. DO NOT use combustibles such as sawdust. Sweep up and collect. Dispose to
approved land-fill or by controlled incineration.
DISPOSAL: If possible, return to supplier. Otherwise, dispose by controlled incineration or to approved land-fill.
FIRE EXPLOSION
Combustible. Containers may rupture if heated strongly. Wear self contained breathing apparatus. If possible remove
containers from the vicinity of the fire. Otherwise keep containers as cool as possible by spraying with water, from a
protected position. Water is not effective for fire fighting and direct contact with water should be avoided. Extinguish
using foam, powder (bicarbonate or ammonium phosphate based) or carbon dioxide.
CONTACT POINT
Emergency Advice
13 11 26
Poisons Information Center
Issue date:
Supersedes issue date:
Reason for issue:
January 2015
January 20013
Company details
APPROVED BY : G>J> Dwyer
This data sheet and the health and safety hazard information it contains is considered to be accurate as at the date of issue. However, no warranty or
recommendation, express or implied, is made as to the accuracy or completeness of the data and information contained within. Each user should
read this data sheet and consider the information in the context of how the product will be handled and used. Health and safety precautions
mentioned in this data sheet may not be accurate for all individuals and/or situations. Guardian Protective Coatings and associated group of
companies shall not be responsible for any damage or injury resulting from abnormal use of the material, from any failure to adhere or observe the
recommendations, or from any hazards inherent in the nature of the material. It is the users responsibility to evaluate the information contained
herein and use this product safely and within the current laws and regulations.
msds.doc