MET 303 Applied Thermodynamics
Assignment 1
Problem 1 (LO-2)
A 3-m-diameter vertical cylindrical tank is filled with water to a depth of 11 m. The rest of
the tank is filled with air at atmospheric pressure. What is the absolute pressure at the
bottom of the tank?
Problem 2 (LO-2)
What would be the barometric pressure reading, in mm Hg, at an elevation of 4 km in the
U.S. standard atmosphere? (Refer to Table C.2 in Appendix C.)
Problem 3 (LO-2)
The closed tank shown below is filled with water and is 5-ft long. The pressure gage on
the tank reads 7 psi. Determine: (a) the height, h, in the open water column, (b) the gage
pressure acting on the bottom tank surface AB, and (c) the absolute pressure of the air in
the top of the tank if the local atmospheric pressure is 14.7 psia.
Problem 4 (LO-2)
A U-tube manometer is connected to a closed tank containing air and water, as shown in
Fig. P2.6.8. At the closed end of the manometer, the air pressure is 16 psia. Determine
the reading on the pressure gage for a differential reading of 4 ft on the manometer.
Express your answer in psi (gage). Assume standard atmospheric pressure and neglect
the weight of the air columns in the manometer.
Problem 5 (LO-2)
Two pipes are connected by a manometer, as shown in Fig. P2.6.11. Determine the
pressure difference, pA − pB, between the pipes.
Problem 6 (LO-2)
For the inclined-tube manometer of Fig. P2.6.14, the pressure in pipe A is 0.6 psi. The
fluid in both pipes A and B is water, and the gage fluid in the manometer has a specific
gravity of 2.6. What is the pressure in pipe B corresponding to the differential reading
shown?
Problem 7 (LO-3)
Determine the magnitude and direction of the force that must be applied to the bottom of
the gate shown below to keep the gate closed.
Problem 8 (LO-3)
A structure is attached to the ocean floor as shown in Fig. P2.8.16. A 2-m-diameter hatch
is located in an inclined wall and hinged on one edge. Determine the minimum air
pressure, p1, within the container that will open the hatch. Neglect the weight of the hatch
and friction in the hinge.
Problem 9 (LO-3)
The 18-ft-long lightweight gate shown below is a quarter circle and is hinged at H.
Determine the horizontal force, P, required to hold the gate in place. Neglect friction at
the hinge and the weight of the gate.
Problem 10 (LO-3)
An iceberg (specific gravity 0.917) floats in the ocean (specific gravity 1.025). What
percent of the volume of the iceberg is under water?