ICT 11 Computer System Servicing (WEEK 2) SUMMATIVE TEST: Multiple Choices: Direction: Choose the letter of correct answer. 1. What tool is used in removing cross-headed screws in the system unit? a. Wire cutter b. Philips head screwdriver c. Cable ties d. Anti-static wrist strap 2. When getting parts that are too small for your hand to fit in what tool should be used. a. Cable ties b. Lint free cloth c. Wire cutter d. Part retriever 3. Which of the following tools does NOT belong to cleaning tools? a. parts organizer b. anti-static wrist strap c. cable ties d. lint free cloth 4. Which of the following hand tools also known as nut driver? a. Flat screwdriver b. Parts retriever c. Hex driver d. Philips screwdriver 5. Which of the following computer hardware is used to prevent ESD? a. Anti-static strap b. Lookback adaptor c. Compressed air d. Multimeter 6. There are different tools needed in repairing computer, which of the following categories does parts retriever, screwdriver, wire cutter and long nose plier belongs? a. Electro-Static Discharge (ESD) tools b. Hand tools c. Cleaning tools d. Diagnostic tools 7. Before using hand tools in performing pc assembly and disassembly, which of the following should be considered. a. Check defective hand tools to be used b. Examine and clean the hand tools c. Never use Personal Protective Equipment d. Select faulty hand tools 8. Evaluate the following statements and select the best answer: Statement 1: Over-tightening screws may cause screw to get stuck on its holes Statement 2: Turn screws clockwise to loosen screws and counterclockwise to tighten screws Statement 3: Stripped screws may still be used but with care a. Only statements 2 and 3 are TRUE b. Only statements 1 and 2 are TRUE c. Only statements 1 and 3 are TRUE d. Only statements 2 and 3 are FALSE 9. Evaluate the following statements select the best answer: Statement 1: It is important to use hex drivers that is larger than a bolt being used Statement 2: Always over-tight bolts to ensure the quality of the thread Statement 3: Hex driver comes in both 6 and 8-sided head a. All statements are TRUE b. Only Statement 1 and 2 are FALSE c. All statements are FALS d. Only statements 2 and 3 are TRUE 10. Evaluate the following statements then select the best answer Statement 1: Properly stored tools and equipment will be easy to find when needed and are less likely to be lost. Statement 2: Using bins for storing small parts is a good practice on proper storage. a. All statements are FALSE b. Only statements 1 is TRUE c. Only Statement 2 is TRUE d. All statements are TRUE
