UCS - IMPACT TESTING REQUIREMENTS MATERIAL SA-516 Gr 70 SA-106 Gr B SA-53 SA-36 START: Assume all part UCS base metal haz require impact testing unless otherwise exempted. Is the governing thickness > 4" (UCS-66(a)(1)(5)) No DT < -155 F [UCS-66(d)] P 1 1 1 1 GR 2 1 1 1 Sí Impact test of base metal and HAZ IS required as per UG-84 Sí UG-20(f) Satisfy all the below conditions: 1. -20 F <= DT <= 650 F 2. Material is P No 1, Gr 1 or 2 3. Hydrotest as per UG-99(b) or UG-99(c) or 27-4 or 35-6 4. No thermal nor mechanical shock loadings 5. No Cyclic loads No Base metal and HAZ impact testing is NOT required Sí Material then has to be curve B, C, or D No Is material Curve A? SEE FIGURE UCS-66 NO Sí Sí Is governing thickness<= 1" UG-(f)(1)(b) Is governing thickness <= 1/2" UG-(f)(1)(a) No Sí Sí No DT is < MDMT shown in Figure UCS-66 UCS-66(a) Sí DT < than MDMT with credit of coicindent ratio UCS-66(b) Sí No No DT < than MDMT including credit for additional PWHT when no required (-30 F) UCS-68(c) Base metal and HAZ impact testing is NOT required No CURVE B B B A