Model CDN10KS9
Coupling/Decoupling Network for Signal Lines
10 kHz–80 MHz
The Model CDN10KS9 is a coupling/decoupling network to couple common mode signals onto 1 to 9 screened
un-balanced wires. The networks are designed to meet the NAMUR NE21 standard requirements. The Coupling Port
Power Level rating on these units will accommodate the higher RF-power required to achieve the desired test level.
This higher power is necessary to compensate for the basic insertion loss from the RF Disturbance port to the EUT
port, the test standard modulation requirements, as well as reflections that may occur in the CDN circuits.
Calibration adapter set CA S2/S3/S4/S9 (set of two adapters for AE and EUT ports) is required for calibration of this
network. 150-50 ohm adapter set (CR00100CD, set of 2) is available for this network. The export classification for
this equipment is EAR99. These commodities, technology or software are controlled for export in accordance with
the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.
SPECIFICATIONS
MODELS
ELECTRICAL
Number of Conductors
Maximum AC voltage EUT/AE Ports
Maximum DC voltage EUT/AE Ports
Current Ratings EUT/AE Ports
RF Coupling Port Frequency Range
RF Coupling Port Voltage Level
RF Port Power Level
RF Coupling Port Impedance
Voltage Attenuation generator/EUT
Insertion Loss EUT/AE
Decoupling Attenuation Generator/AE
Common Mode Impedance at
EUT Connector
Coupling Factor
MECHANICAL
I/O Connectors
RF Coupling Port Connector
CDN10KS9
1 to 9
<350V
<600V
3A
10 KHz – 80 MHz
<30 V
45W
50 Ω
10 dB +1 dB/-3 dB
<3 dB up to 20 kHz
<10 dB up to 1 MHz
<20 dB up to 10 MHz
>50 dB up to 20 MHz
>20 dB at 80 MHz
10 kHz to 26 MHz: 150 ±20 Ω
26 MHz to 80 MHz: 150 +60 Ω /-45 Ω
0 dB + 0 dB/-3 dB
S9 Centronics, D Sub min
N Female
Approved for public release by AR RF/Microwave Instrumentation
160 School House Road Souderton, PA 18964-9990 • 215-723-8181 • www.ar-worldwide.com
040512
Page 1 of 1