SA-LSU4.2-000 Bosch LSU 4.2 lambda probe Key Features High signal resolution and accuracy because of linear probe range Quick response time ≈ 50 Hz No temperature drift because of heater control Long operating life Measuring range λ 0.65 to ∞ (air) or 6 to 16 A/F Fast heating (ready for control ~ 30 s) Technical specifications Electrical characteristics Probe supply voltage Operating exhaust gas temperature Maximum exhaust gas temperature A/F ration in combination with BC-LSU2CAN Heating power in combination with BC-LSU2CAN Linear output (A/F ratio) from Heater control frequency Nominal resistance of Nernst cell V °C °C A/F A Hz Ω Environmental data Storage temperature Max. vibration (stochastic peak) 12 930 <1030 6 to 16 Max. 2 6:1 to 16:1 <2 80 Mechanical characteristics Probe weight (w/o cable) Probe length Thread Cable length (excl. probe) Wrench size Tightening torque mm mm Nm 120 84 M18x1.5 520 22 40…60 Ordering information Art.No. SA-LSU4.2-000 °C -40 to +100 G 100 Connector layout Bosch connector Pin Name 1 IP 2 UN 3 VM 4 Heater 5 Heater + 6 RT g mm Connector type Description Inverting input current amplifier Inverting input current control Virtual ground current control Ground for heater Power for heater Trim resistance Color Red Black Yellow White Grey Green Connector probe Inside each probe connector is a specific trim resistor. Cutting off the connector without replacing this resistor will cause wrong measuring results. DO NOT FORGET to connect the resistor again if you have to replace the connector and/or keep the original plug in case of contacting 2D support. The specifications on this document are subject to change at 2D decision. 2D assumes no responsibility for any claims or damages arising out of the use of this document, or from the use of modules based on this document, including but not limited to claims or damages based on infringement of patents, copyrights or other intellectual property rights. 21.10.2013/LK 2D Debus & Diebold Meßsysteme GmbH http://www.2D-datarecording.com mail@2D-datarecording.com