id+3.5" square housing

advertisement
id+ 3.5" square housing
FLC33D | FLC33W
LUMINAIRE MUST BE INSTALLED PRIOR TO DRYWALL CEILING.
ALL GRID LUMINAIRES MUST BE SECURED TO STRUCTURE ABOVE.
non-emergency
- thermally protected, non-ic
key
bar hangers
grid
- sold separately
- included
power off
drywall/hard ceiling
power on
attention
FLC33D | FLC33W
emergency
level
- remote test switch, non-ic
ic/cp
see additional
instructions
WALL WASH ORIENTATION
WALL
FLC33D | FLC33W
FLC33D | FLC33W
1
4 1/8”
FOR ASTM E-283 AIR-TIGHT
COMPLIANCE, SEAL IC HOUSING/
RO TRIM WITH SILICONE CAULKING
BETWEEN THE EDGE OF THE COLLAR
AND CEILING MATERIAL. SEAL ALL
ADDITIONAL HOLES IN HOUSING
WITH ALUMINUM TAPE.
4 1 / 8”
ceiling cutout
GRID - 1/2" CONDUIT & CLIP (BY OTHERS)
2
X2
3
4
x4
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
IS0630 REV. A
2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
1 of 3
GRID - BAR HANGERS (SOLD SEPARATELY)
2
x2
3
4b
multiple luminaires only
4a
x4
DRYWALL - BAR HANGERS
WOOD STUDS
2a x4
METAL STUDS
2b
x4
3
x4
4
minimum ceiling thickness: 1/2"
5
maximum ceiling thickness: 1-1/2"
make electrical connections
Fixtures must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
IS0630 REV. A
2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
2 of 3
EMERGENCY - REMOTE TEST SWITCH
1
2
ABOVE CEILING ACCESS REQUIRED
4.125”
3
7.301" ± 0.58"
release
test switch
from bracket
prior to
installation
11
4
5.246 ± 0.58"
3.191 ± 0.58"
Ø 0.75"
5
adjust test switch until
canopy is flush with ceiling
6
BATTERY UNIT CONNECTOR INSIDE
EM- MOUNTING HEIGHT
11
7
SEE BATTERY
MANUFACTURER
INSTRUCTIONS
DO NOT MATE BATTERY
UNIT CONNECTOR
UNTIL INSTALLATION
IS COMPLETE AND A.C.
POWER IS SUPPLIED
SEE BATTERY MANUFACTURER
INSTRUCTIONS
emergency maximum mounting height:
20.7'
WALLWASH: 15.6'
DOWNLIGHT:
DRIVER SERVICE
1
2
Contractor is responsible for adequately reinforcing walls and/or ceilings to support fixture weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls and/or
ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0630 REV. A 2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
3 of 3
Download