Automation Interface Module (AIM) Worksheet Communications Interface Module (CIM) Worksheet

advertisement
Automation Interface Module (AIM) Worksheet
Communications Interface Module (CIM) Worksheet
Directions: Fill in section 1: Document the desired status and control points for each lighting panel. Please indicate the # of relays in each panel and
whether you would like to just check status or if you would also like to issue commands. If the panels have the same command and status requirements,
you may submit one sheet that has all applicable panels listed in the space provided at the bottom of this section. Fill in section 2 on one sheet only.
Section I
Relay Outputs
Relay
Check Relay
Status
Issue Relay
Commands
If you wish to issue
commands to this relay as
part of a command group,
please indicate group #
that this relay belongs to.
Local Contact Inputs
Notes
Input
01
01
02
02
03
03
04
04
05
05
06
06
07
07
08
08
09
09
10
10
11
11
12
12
13
13
14
14
15
15
16
16
17
17
18
18
19
19
20
20
21
21
22
22
23
23
24
24
25
25
26
26
27
27
28
28
29
29
30
30
31
31
32
32
Check
Input
Status
Notes
33
34
35
36
37
Analog
Input
38
01
39
02
40
03
41
04
Check Input On/Off
Status
Check Analog
Reading
42
43
44
45
46
47
48
Lighting Control Relay Panel Information
Panel Type
Panel Address
Panel Location
Panel Address
Panel Location
Panel Address
Panel Location
Panel Address
Panel
(1 type per sheet)
Page 5
Section II
Setup Information (Fill in on one sheet only and
choose only one protocol)
COMPLETE
ONLY ONE
SECTION
BELOW
Automation Interface Module (AIM)
Communications Interface Module (CIM)
What Protocol will you be using? (circle one)
BACnet
Modbus
LON
BACnet
I will be using BACnet over IP
I will be using BACnet over Ethernet
(Please provide the following information for proper
configuration)
IP Address
(Please provide the following information for proper
configuration. Please note – the MAC address
information of the unit will be provided on the final
mapping table once the unit is configured)
Subnet Mask
BACnet Network Number
Default Gateway IP Address
Desired BACnet Device Object Instance ID#
BACnet Network Number
Desired BACnet Device Object Instance ID#
I will be using BACnet over ARC156
I will be using BACnet over MS/TP
(Please provide the following information for proper
configuration)
(Please provide the following information for proper
configuration)
Desired ARCnet Address
Desired MS/TP Address
BACnet Network Number
BACnet Network Number
Desired BACnet Device Object Instance ID#
Desired BACnet Device Object Instance ID#
What is the desired baud rate
What is the desired Max Master setting? (default is 127)
Modbus
Choose Protocol Configuration: Baud Rate Data Bits Expected
Choose Protocol Configuration
Baud Rate
Data Bits Expected
RTU
1200
8
ACCII
2400
7
4800
Choose Com Type
9600
Stop Bits Expected
RS232
19200
1
2wire RS485
38400
2
4 wire RE485/422
Parity
Indicate Desired Slave Address
Odd
Even
None
N2
What N2 slave address should be assigned to the AIM?
(This address must be different from any other N2 device on the N2 BUS.)
LON
No additional Information needed
N2
Download