Name:
Date:
Gavilan College AMT 100
Hand Tools & Measuring Devices
Worksheet #1
Points: 36
Screwdrivers are classified by:
1.
2.
3.
4. A common screwdriver must fill at lease
of the screw slot.
5. If a common screwdriver is the wrong size, it will
screw slot.
and
6. Duckbill pliers are used for
7. Why are pliers not used to turn nuts?
8. What tool is used to make indentations in metal to start a twist drill?
9. Why is a prick punch or center punch never used to remove objects from a hole?
10. What is one of the most widely used metals used to make wrenches?
11. Flare nut wrenches are commonly used on?
12. Torque wrenches measure what?
13. Hack saw teeth point which direction?
14. What type of file is used for circular and concave surfaces?
15. What type of file provides a superior finish?
16. What tools is used to clean a file?
17. The most common cutting angle for a twist drill?
18. Reamers are used to
19. Reamers should be turned in only one direction. (T or F)
20. What is the standard countersink angle used in aviation?
21. What tool is used to control the depth of a countersink cut?
Three types of taps are:
22.
23.
24.
Page 1 of 2
the
What are the three heads of a combination set?
25.
26.
27.
28. A vernier micrometer (has a vernier scale) can measure in increments down to?
29. What tool would you use to measure the amount of runout or bend in a shaft?
Use the figure above and name the components:
30. A.
31. B.
32. C.
33. D.
34. E.
35. F.
36. G.
Page 2 of 2