Lenntech
36 [1.42 in] or 29 [1.14 in]- FOR NON-CODE
TYPx2 (FOR VICTAULIC)
14
15
GENERAL DRAWING
16
info@lenntech.com Tel. +31-152-610-900
www.lenntech.com Fax. +31-152-616-289
17
214 [8.43 in]
BODY DIA.
249 [9.80 in]
PEAK BELL DIA.
in]
DANGER
10[0.4in]max.
FEED
9 [0.35 in]- ASME
2 [0.079 in]
TYPx2
45 [1.77 in]
229 [9.02 in]
S
PORT
SUPPORT
166 [6.54 in]
2
2.
SCREW HEX HEAD
DIN 933 OR
DIN EN 24017
M8x70
20
117 [4.6 in]
[7
.9
6
HIGH PRESSURE
3 SUPPORTS REQUIRED FOR LENGTH CODE - 4 AND OVER
CONCENTRATE
SUPPORT
10
11
12
9
30 [1.18 in]
13
FEED/CONC. PORT
1.5" VICTAULIC
1. All dimensions are for reference only, not for construction
unless certified.
2. Item 14 & 15 should be located on feed side.
3. Drawing unit: mm. (inches)
4. Saddles can be shimmed if required.
5. Do not scale drawing, may be reprinted on any paper size
or copied.
6. Length between ports (P) can be changed to adapt old
dimension - with customer's special request.
7. The vessel is supplied with two strap assembly.
Warning.
1. Never pressurize a pressure vessel that was not loaded with membrane elements.
2. Wrong manifolding may effect an excessive load on port what can lead to leaks.
3. Max. allowable working pressure not to exceed 300 psi. (20.7 bar).
M (REF.)
4. Permeate internal pressure not to exceed 125 psi. (8.6 bar).
5. Operating temperature not to exceed 49 C (120 F).
Notes:
PORT
PERMEATE PORT
1.5" NPT-MALE
(option: 1.5" VICTAULIC
or 1" BSP FEMALE)
ASME CODE
TYPE
8
13
2
3
12
11
4
6
10
9
7
30 [1.18 in]
1
M (REF.)
NON-CODE
TYPE
TITLE
DRAWING No.
1
2
3
4
5
7
BEL 8-S-300 psi.
RO PRESSURE VESSEL
8s15-300/300A
DESIGN Daria P.
CHECK Yuri V.
Ari A.
APPR.
REV.: 8