GENERAL DRAWING

advertisement
19
GENERAL DRAWING
20
53 [2.09 in]
TYPx2
214 [8.43 in]
BODY DIA.
240 [9.45 in]
PEAK BELL DIA.
61 [2.4 in]
18
in]
1 [0.04 in]
TYPx2
17
96
DANGER
FEED
20
2.
117 [4.61 in]
2
[7
.
HIGH PRESSURE
SCREW HEX HEAD
DIN 933 OR
DIN EN 24017
M8x70
45 [1.77 in]
229 [9.02 in]
10[0.4in]max.
SUPPORT
PORT
CONCENTRATE
SUPPORT
PERMEATE PORT
1.25" BSP-MALE
S
3 SUPPORTS REQUIRED FOR LENGTH CODE - 4 AND OVER
FEED/CONC. PORT
1.5" VICTAULIC
Notes:
Lenntech
1. All dimensions are for reference only, not for
construction unless certified.
2. Item 17 & 18 should be located on feed side.
3. Drawing unit: mm. (inches)
4. Saddles can be shimmed if required.
5. Do not scale drawing, may be reprinted on any
paper size or copied.
6. The vessel is supplied with two strap assembly.
info@lenntech.com Tel. +31-152-610-900
www.lenntech.com Fax. +31-152-616-289
16
This drawing is an integral part of
the general statement of use
and Technical Manual
15
14
13
12
11
10
8
20 [0.79 in]
7
M (REF.)
1
2
3
4
5
6
Warning.
1. Never pressurize a pressure vessel that was not loaded with membrane elements.
2.
3. Max. allowable working pressure not to exceed 300 psi. (20.7 bar).
4. Permeate internal pressure not to exceed 125 psi. (8.6 bar).
5. Operating temperature not to exceed 49 C (120 F).
TITLE
DRAWING No.
BEL 8-E-300 psi.
RO PRESSURE VESSEL
8e-300
DESIGN Daria P.
CHECK Yuri V.
Ari A.
APPR.
REV.: 4
Download