August
T05 /T24/TES021/TML021/EE/20150811
Marks-80
2015
Instructions:
Engineering Drawing - 1
1. All questions are compulsory.
2. “Long Answer type Question (LAQ)” is a supply type question
of 15 marks which required a typical answer of about 60-80 lines
in bout 32-40 minutes.
3. “Sort Answer type Question (SAQ)” is a supply type question of
5 marks which required a typical answer of about 15-20 lines in
bout 08-10 minutes.
4. Figures to the right indicate marks allotted to the questions.
5. Assume suitable data if necessary
6. Use a nonprogrammable type of scientific calculator is allowed
Marks
SECTION-A
Q.1
Explain any five major items containing in a drawing instrument box.
Sketch them.
15
OR
Q.1
What are the different practical hints on dimensioning? Explain in detail with
a sketch.
15
Q.2
(a) Construct a rectangle of sides 65mm and 40mm long.
10
(b) Inscribe a regular hexagon in circle of 60mm diameter.
05
OR
Q.2
(a) The vertex of a hyperbola is 65mm from its focus. Draw the curve
if the eccentricity is 3/2. Draw a normal and a tangent at a point on the
curve 75mm from the directrix.
15
Q.3
What is the general suggesting for drawing sheet?
05
Q.4
What are the different types of engineering curve?
05
SECTION-B
Q.5
Figure shows a bracket. Draw an orthographic projection of it by using
first angle projection methods.
i)
Front view
ii)
Top view
iii)
Left hand side view
15
OR
Q.5
A point P is 15 mm above the HP and 20 mm front of the VP. Another
points Q is 25mm behind the VP and mm below the HP. Draw
projections of P and Q keeping the distance between their projectors
equal to 90 mm. Draw straight lines their joining their top views and
front views.
15
Q.6
Draw the projections of a square ABCD of 50 mm side has its corner
A in the HP. Its diagonal AC inclined at 30° to the HP and the
diagonal BD inclined at 45° to the VP and parallel to the HP.
15
OR
Draw the projections of cube of 25 mm long edges resting on the HP
on one of its corners with a solid diagonal perpendicular to the VP.
15
Q.7
What are the different types of projection method?
05
Q.8
Explain the types solids.
05
Q.6