*Delete as appropriate
BACHELOR OF SCIENCE DEGREE / DEGREE WITH HONOURS IN
ELECTRIACL ENGINEERING
Senior Design Project Report
Department of Electrical Engineering
Qatar University
ENTER YOUR PROJECT TITLE
Report by
ENTER YOUR NAME HERE
Supervisor
ENTER YOUR SUPERVISOR NAME HERE
Date
SELECT DATE OF SUBMISSION HERE
Department of Electrical Engineering
Senior Design Project Report
DECLARATION STATEMENT
We, the undersigned students, confirm that the work submitted in this project report is entirely our
own and has not been copied from any other source. Any material that has been used from other
sources has been properly cited and acknowledged in the report.
We are fully aware that any copying or improper citation of references/sources used in this report will
be considered plagiarism, which is a clear violation of the Code of Ethics of Qatar University.
In addition, we have read and understood the legal consequences of committing any violation of the
Qatar University’s Code of Ethics.
Student Name
Student ID
Signature
Date
1
2
3
4
ENTER YOUR PROJECT TITLE
i
Department of Electrical Engineering
Senior Design Project Report
SUPERVISOR APPROVAL SHEET
The project report submitted by ENTER YOUR NAME HERE was reviewed and I/We accept and
approve the report to be examined. To the best of my/our knowledge, the report conforms to the
requirements of the Department of Electrical Engineering.
Name of the Supervisor (s):
Signature (s):
Date:
ENTER YOUR PROJECT TITLE
ii
Department of Electrical Engineering
Senior Design Project Report
ABSTRACT
ENTER YOUR ABSTRACT HERE - The abstract should not be longer than 400 words and is a short
summary describing the contents of the report, rather than being a summary of the project. The
abstract is not intended to replace any other part of the report e.g. the introduction. It merely provides
a taste for what is to come.
ENTER YOUR PROJECT TITLE
iii
Department of Electrical Engineering
Senior Design Project Report
ACKNOWLEDGEMENTS
ENTER YOUR ACKNOWLEDGEMENT HERE - This section includes thanks to all people who have
helped you.
ENTER YOUR PROJECT TITLE
iv
Department of Electrical Engineering
Senior Design Project Report
TABLE OF CONTENTS
DECLARATION STATEMENT ................................................................................................................. i
SUPERVISOR APPROVAL SHEET ....................................................................................................... ii
ABSTRACT .............................................................................................................................................iii
ACKNOWLEDGEMENTS ...................................................................................................................... iv
LIST OF FIGURES ................................................................................................................................. vi
LIST OF TABLES ...................................................................................................................................vii
GLOSSARY .......................................................................................................................................... viii
Chapter 1 [Enter Chapter Title Here] ...................................................................................................... 1
1.1
[ENTER SUB-CHAPTER TITLE HERE] ................................................................................. 1
1.2
[ENTER SUB-CHAPTER TITLE HERE] ................................................................................. 2
1.2.1
[LOWEST LEVEL SUB-SUB CHAPTER] ....................................................................... 2
1.2.2
[LOWEST LEVEL SUB-SUB CHAPTER] ....................................................................... 2
Chapter 2 [Chapter Title] ......................................................................................................................... 3
2.1
Sub-Chapters .......................................................................................................................... 3
2.2
Sub-Chapters .......................................................................................................................... 3
Chapter 3 Another Chapter ..................................................................................................................... 4
3.1
Sub-Chapters .......................................................................................................................... 4
3.2
Sub-Chapters .......................................................................................................................... 4
REFERENCES ........................................................................................................................................ 5
BIBLIOGRAPHY ..................................................................................................................................... 6
[Table of contents is automatically generated if you use section headings. Otherwise, create your own
table of contents here. To update the Table of contents, Right-click on the TOC area and click Update
Fields or Press F9. Ensure that you do not modify any text in the TOC area. All modification should
be performed in the appropriate chapter/sub-chapter/sub-sub-chapter.]
ENTER YOUR PROJECT TITLE
v
Department of Electrical Engineering
Senior Design Project Report
LIST OF FIGURES
Figure 1-1 This is a sample figure ........................................................... Error! Bookmark not defined.
[List of figures is automatically generated if you use figure captions. Otherwise, create your own list of
figures here. To update the List of Figures, Right-click on the LOF area and click Update Fields or
Press F9. Ensure that you do not modify any text in the LOF area. All modification should be
performed in the appropriate caption of the figure.]
ENTER YOUR PROJECT TITLE
vi
Department of Electrical Engineering
Senior Design Project Report
LIST OF TABLES
Table 1-1 This is a sample table caption. .............................................................................................. 2
[List of tables is automatically generated if you use Table captions. Otherwise, create your own list of
tables here. To update the List of Tables, Right-click on the LOF area and click Update Fields or
Press F9. Ensure that you do not modify any text in the LOF area. All modification should be
performed in the appropriate caption of the table.]
ENTER YOUR PROJECT TITLE
vii
Department of Electrical Engineering
Senior Design Project Report
GLOSSARY
[ENTER YOUR GLOSSARY HERE - This section consists of a list of all specialist vocabulary or
acronyms with a brief description of their meanings.]
ENTER YOUR PROJECT TITLE
viii
Department of Electrical Engineering
Senior Design Project Report
Chapter 1 [ENTER CHAPTER TITLE HERE]
The first page of chapter 1 is designated page 1 of the report such that any pages before chapter 1
can be numbered in formal numbers i.e. i, ii, iii, iv, v, …
The main body of the report should typically contain the following sections (please refer to the student
handbook for more details about the content of each section):

Introduction

Literature review

Description of the project work

Results and discussions

Conclusion and future work
Due to the diversity of projects, students should consult their project supervisor about the most
appropriate structure for their SDPs.
Number all paragraphs but do not use more than three levels e.g. 1.2.4 but not 1.2.4.1. Use
alphabets, bullet points, etc. if you feel it is necessary to have further sub-sections.
Chapters may start with an introduction; number all sub-sections but do not use more than three
levels e.g. 2.1.4 but not 2.1.4.1. Use alphabets, bullet points, etc… if you feel it is necessary to have
further sub-sections.
1.1
[ENTER SUB-CHAPTER TITLE HERE]
This is where you type your main text. Figures and Tables must have captions associated to them.
Use Figure Text or Table text Styles for text formatting in the figures and tables respectively. Please
refer to the examples below:
Signal Acquisition and Processing Unit
Emergency Response Unit
GP
GPRS
Module
Bluetooth
Module
GP
RS
GP
RS
GP
RS
RS
SpO2: 85%, HR: 130 bpm
QEWS: 6
GPS: 85.500923, 25.320211
Microcontroller
Bluetooth Pulse
Oximeter
GPS
Module
SMS Center
(a)
Figure 1-1 This is a sample figure
ENTER YOUR PROJECT TITLE
1
Department of Electrical Engineering
Senior Design Project Report
Table 1-1 This is a sample table caption.
A
1
B
2
C
3
D
4
[To insert a caption for a picture, Right-Click on the picture and click on Caption, or alternatively,
highlight the appropriate picture, select Insert->Reference->Caption. You are advised to use word to
automatically generate and manage figure numbers. Otherwise, you’ll end up having to manually
adjust figure numbers to match List of Figures.]
All tables, diagrams, charts and graphs must be referenced in the text (using figure numbers) and
need to be followed by a caption that briefly describes the table, diagram, chart or graph; the caption
should include some form of numbering.
1.2
[ENTER SUB-CHAPTER TITLE HERE]
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here.
1.2.1 [LOWEST LEVEL SUB-SUB CHAPTER]
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here
1.2.2 [LOWEST LEVEL SUB-SUB CHAPTER]
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here
ENTER YOUR PROJECT TITLE
2
Department of Electrical Engineering
Senior Design Project Report
Chapter 2 [CHAPTER TITLE]
2.1
Sub-Chapters
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here
2.2
Sub-Chapters
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here
ENTER YOUR PROJECT TITLE
3
Department of Electrical Engineering
Senior Design Project Report
Chapter 3 ANOTHER CHAPTER
3.1
Sub-Chapters
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here.
3.2
Sub-Chapters
Enter your text here. Enter your text here. Enter your text here. Enter your text here. Enter your text
here. Enter your text here. Enter your text here. Enter your text here
ENTER YOUR PROJECT TITLE
4
Department of Electrical Engineering
Senior Design Project Report
REFERENCES
[1]
Reference 1
[2]
Reference 2
[3]
Reference 3
[ENTER YOUR REFERENCES HERE - Information obtained from books, conference and journal
papers, or the Internet must be referred to in the text using the IEEE referencing style.
References to text books should include the author, title, edition number or year, name of publisher
and page numbers or section numbers.
Each reference must be referred to at least once in the main body of the report.
References to web pages should include the title of the page, not just the URL.
Students will be penalised if material from published sources is included in their reports without full
acknowledgement and attribution of the source of the material.]
ENTER YOUR PROJECT TITLE
5
Department of Electrical Engineering
Senior Design Project Report
BIBLIOGRAPHY
[ENTER YOUR BIBLIOGRAPHY HERE - Books and other reading matter not specifically referred to
in the text but considered useful reading matter should be listed in the Bibliography. The format of the
items in the bibliography should be the same as for references i.e. there should be full information to
allow a reader to obtain a copy of the text book or journal article.]
ENTER YOUR PROJECT TITLE
6
Department of Electrical Engineering
Senior Design Project Report
Appendix A APPENDIX TITLE
[ENTER APPENDICES HERE - Detailed mathematical derivations, component data, software listing
and general detailed backup material should be outlined to the appendices. The appendices should
not form the bulk of the report.
IC manufacturer's data sheets should only be included for unusual devices and even then, only a few
relevant pages should be included.]
A.1 Appendix Sub-Heading 1
A.1.1 Appendix Sub-Heading 2
ENTER YOUR PROJECT TITLE
7