MSDS #CR22
 MATERIAL SAFETY DATA SHEET 
HEALTH
FLAMMABILITY
REACTIVITY
BIG SKY COMPLIANCE COATINGS
CR22 Clearcoat
2
3
FOR SALE IN CANADA AND MEXICO ONLY.
NOT TO BE SOLD IN THE U.S.
0
Revised Date: 1/05/2006
SECTION I. MANUFACTURER
Montana Products, Inc.
9287 Smucker Road
Orrville, OH 44667
1-888/276-7071
1-800/328-4892
1-800/424-9300
Telephone:
Corporate Office:
Chemtrec Emergency:
Products on this MSDS:
CR22
OSHA Hazard Class: Flammable Liquid
DOT Shipping Class: Paint Related Material
Hazardous Materials Information: See Section II.
SECTION II. HAZARDOUS INGREDIENTS
INGREDIENTS
CAS#
VAPOR
SARA
PRESSURE
313
20°C (MMHg) REPORT
EXPOSURE LIMITS
OSHA
ACGIH
STEL
CEILING
1. Butyl Acetate
123-86-4
8.40
No
150 ppm
150 ppm
200 ppm*
----
2. Methoxy Propyl Acetate
108-65-6
3.80
No
N/E
N/E
N/E
----
3. Methyl Amyl Ketone
110-43-0
2.10
No
100 ppm
100 ppm
50 ppm
----
4. Methyl Ethyl Ketone
78-93-3
70.00
Yes
200 ppm
200 ppm
300 ppm
----
5. Toluene
108-88-3
36.00
Yes
100 ppm
6. Ethyl 3-Ethoxy
Propionate
763-69-9
1.11
No
N/E
WT %
25 - 30
Skin 50 ppm 150 ppm 200 ppm**
----
50 ppm
5 - 10
----
* Denotes 15 Minutes/** Denotes 10 Minutes
Note: Each product that has “yes” listed under the SARA 313 column is subject to the reporting requirements of Section
313 of the Emergency Planning and Right to Know Act of 1986 and 40 CFR 372.
SECTION IIB. HAZARDOUS INGREDIENTS
INGREDIENT
1. Butyl Acetate
2. Methoxy Propyl Acetate
3. Methyl Amyl Ketone
4. Methyl Ethyl Ketone
5. Toluene
6. Ethyl 3-Ethoxy Propionate
LD50
LC50
8532 mg/kg rat oral
75000 mg/kg rabbit dermal
SECTION III. PHYSICAL DATA
Also see Section X.
Boiling Range:
Solubility in H2O:
Volatile (%) by Volume:
Weight per Gallon:
MSDS #CR22
180°F - 330°F
NIL
71.74
7.89 lbs./gal.
Evaporation Rate:
Vapor Density:
Volatile (%) by weight:
VOC:
MONTANA PRODUCTS, INC. CR22 CLEARCOAT
Slower than Ether
Heavier than Air
66.16
5.22 lbs/gallon
Page 1 of 3
SECTION IV. FIRE AND EXPLOSION
Flash Point: 28°F
Sensitivity to Mechanical Impact:
Flammable Limits: 8 - 13%
T.D.G. Flam Class:
3
Extinguishing Media:
CO2 / Foam
Explosive Power:
Not Available
Rate of Burning:
Not available
No
Special Fire Fighting Procedures:
The use of SCBA is recommended for fire fighters. Water spray may be useful in cooling containers exposed to
heat and flame. Avoid spreading burning liquid with water used for cooling purposes. Fight as volatile liquid
fire. Closed containers may explode when exposed to extreme heat. Use water to cool fire exposed containers.
Unusual fire and explosion hazards:
This material may be ignited by heat, sparks, flame, or static electricity. Keep containers closed when not in use.
Isolate from heat, sparks, pilot lights, smoking materials, and other sources of ignition.
SECTION V. HEALTH HAZARD DATA
General Effects:
Ingestion: Gastrointestinal distress. In the unlikely event of ingestion call a physician immediately and have the
names of the ingredients available.
Inhalation: May cause nose and throat irritation. Repeated and prolonged overexposure to solvents may lead to
permanent brain and nervous system damage. Eye watering, headaches, nausea, dizziness and loss of
coordination are signs that solvent levels are too high. If affected by inhalation of vapor or spray mist, remove to
fresh air. If breathing difficulty persists, or occurs later, consult a physician.
Skin or Eye Contact: May cause irritation or burning of the eyes. Repeated or prolonged liquid contact may
cause skin irritation with discomfort and dermatitis. In case of eye contact, immediately flush with plenty of
water for at least 15 minutes; call a physician. In case of skin contact, wash with soap and water. If irritation
occurs, contact a physician.
Specific Effects:
Butyl Acetate: May cause abnormal liver function.
Methoxy Propyl Acetate: May cause moderate eye burning. Continuous re-over exposures may result in liver
and kidney injury.
Methyl Amyl Ketone: Ingestion studies on laboratory animals showed that high oral doses caused increased
liver and kidney weights.
Methyl Ethyl Ketone: High concentrations have caused embryo toxic effects in laboratory animals. Liquid
splashed in the eyes may result in chemical burns.
Toluene: Reoccurring overexposure may cause liver or kidney damage. High airborne levels have produced
irregular heartbeats in animals and occasional palpitations in humans. Rats exposed to very high
airborne levels have exhibited high frequency hearing deficits. Warning: This chemical is known to
the state of California to cause birth defects or other reproductive harm.
SECTION VI. REACTIVITY DATA
Stability: Stable
Incompatibility (Materials to avoid): None reasonably foreseeable.
Hazardous Decomposition Products: CO2,
Hazardous Polymerization: Will not occur.
SECTION VII. SPILL OR LEAK PROCEDURES
Steps to be taken in case material is released or spilled: Ventilate area. Remove sources of ignition. Prevent skin contact
and breathing of vapor. Wear a properly fitted vapor/particulate respirator (NIOSH/MSHA TC-23C). Confine
and remove with inert absorbent.
Waste Disposal Method: Do not allow material to contaminate ground water systems. Incinerate absorbed material in
accordance with federal, state, and local requirements. Do not incinerate in closed containers.
MSDS #CR22
MONTANA PRODUCTS, INC. CR22 CLEARCOAT
Page 2 of 3
SECTION VIII. SPECIAL PROTECTION INFORMATION
Do not breathe vapors or mists. Wear a properly fitted vapor/particulate respirator approved by NIOSH/MSHA (TC-23C)
for use with paints during application and until all vapors and spray mists are exhausted. In confined spaces or in
situations where continuous spray operations are typical or proper respirator fit is not possible, wear a positive-pressure,
supplied-air respirator (TC-19C). In all cases, follow the respirator manufacturer’s direction for respirator use. Do not
permit anyone without protection in the painting area.
Ventilation: Provide sufficient ventilation in volume and pattern to keep contaminants below applicable OSHA
requirements.
Protective Clothing: Neoprene gloves and coveralls are recommended.
Eye Protection: Desirable in all industrial situations. Include splashguards or side shields.
SECTION IX. SPECIAL PRECAUTIONS
Precautions to be taken in handling and storing: Observe label precautions. Keep away from heat, sparks and flame.
Close container after each use. Ground containers when pouring. Wash thoroughly after handling and before
eating or smoking. Do not store above 120°F.
Other Precautions: Do not sand, flame cut, braze or weld dry coating without a NIOSH/MSHA approved respirator or
appropriate ventilation.
SECTION X. REGULATORY INFORMATION
T.D.G. Classification: Paint, UN1263, Class 3, PG 111
WHIMIS Classification:
SECTION XI. TOXICOLOGICAL INFORMATION
LD50 of Product (species and route):
Not available for mixture. See Section II for individual comparisons
LC50 of Product (species and route):
Not available for blend. See Section II for individual comparisons
Xylene: when present it can be assumed 18-20% of the Wt. % reported is Ethylbenzene.
Flash Point: Determined by TCC, expressed in degrees Fahrenheit.
Coating VOC: WS – WW - WEX
Reperesents VOC per EPA Method 24.
VT – VW - VEX
Material VOC: wS-wW-wEX
Where: WS = total solvent weight
WW = weight of water
WEX = weight of exempt solvent
VEX = volume of exempt solvent
VW = volume of water
VT = total volume
Warning: KEEP THIS AND ALL PAINT RELATED PRODUCTS OUT OF THE REACH OF CHILDREN!
The information contained in this MSDS is based on data from sources considered to be reliable but Montana Products,
Inc. does not guarantee the accuracy or completeness thereof. Montana Products, Inc. urges each customer or recipient of
this MSDS to study it carefully to become aware of and understand the hazards associated with this product. The reader
should consider consulting reference works or individuals who are experts in ventilation, toxicology or fire prevention as
necessary or appropriate to use and understand the data in this MSDS.
Note: The data on this MSDS relates only to individual components and does not represent the end mixed
product. Read all other Component Material Safety Data Sheets.
 END OF MSDS 
MSDS #CR22
MONTANA PRODUCTS, INC. CR22 CLEARCOAT
Page 3 of 3