Specifications:
[1]
Main Front Speaker [2] Qty. [Bose, JBL, Sonodyne, Quest Make]
System Type: Dual 15" 2-way, sound reinforcement speaker
4_ Frequency Range (-10 dB)1: 56 Hz – 18 kHz
2_ Frequency Range (-10 dB)1: 42 Hz – 18 kHz
4_ Frequency Response (±3 dB)1: 83 Hz – 13 kHz
2_ Frequency Response (±3 dB)1: 62 Hz – 13 kHz
Sensitivity (1w/1m): 100 dB
Nominal Impedance: 4 _
Power Capacity:1 500 watts
Peak Power Capacity:1 2000 watts
Recommended Amplifier
Power: 500-1000 watts @ 4 _
Maximum SPL: 133 dB
Nominal Dispersion: 90° x 50°
Crossover Frequency: 2.2 kHz
Dimensions (H x W x D):3 1092 mm x 464 mm x 432 mm
(43 in x 18.3 in x 17 in)
Weight: 42.6 kg (94 lb)
Shipping Weight: 46.7 kg (103 lb)
High Frequency Driver: JBL 2414H-C , 1" exit compression driver mounted on
Progressive Transition™ Waveguide
Low Frequency Driver: JBL M115-8A x 2
Input Connectors: Neutrik® Speakon® NL-4 (x1); ¼" TS phone jack (x1); parallel
Enclosure Construction: 19 mm (¾ in) MDF (Medium Density Fiberboard); with
glued and mechanically fastened joint detail; covered in
black carpet .
Grille: 18-gauge, powder-coated steel
Mounting & Suspension: None
Rear Speaker
I
[2] Qty. Specifications:[Bose, JBL, Sonodyne, Quest Make]
Frequency Range1 (-10 dB): 60 Hz - 16 kHz
Frequency Response1 (±3 dB): 70 Hz - 12 kHz
Sensitivity (1w/1m): 99 dB SPL
Nominal Impedance: 8 Ω
Power Capacity2: 250 watts
Peak Power Capacity2: 1000 watts
Recommended Amplifier Power: 250 watts to 500 watts into 8 Ω
Maximum SPL: 129 dB
Nominal Dispersion: 90° x 50°
Crossover Frequency: 1.8 kHz
Dimensions (H x W x D): 584 mm x 399 mm x 325 mm
(23 in x 15.7 in x 12.8 in)
Weight: 19.5 kg (43 lb)
High Frequency Driver: JBL 2412 1” exit compression driver mounted
on Progressive Transition™ Waveguide
Low Frequency Driver: JBL M112-8
Input Connectors: Neutrik® Speakon® NL-4 (x1); 1/4” TS phone jack (x1); parallel
Specification
Podium Microphone
[02] Qty [Shure , AKG Make]
Bass filter 250 Hz, -10 dB bei 50 Hz
Impedance <=600 ohms
Recommended load
impedance
>=2,000 ohms
Supply voltage 9 to 52 V phantom power to DIN/IEC
Powering <=3.5 mA
Connector 3-pin male XLR
Finish matte dark grey
Dimensions
max. dia.: 20 mm (0.8 in.), length: 260/405/600 m (10.2/15.9/23.6
in.)
Net weight
140/430 g (4.9/15.2 oz.), 110/522 g (3.9/18.4 oz.), 194/573 g
(6.8/20.2 oz.)
©2012 AKG Acoustics, Austria
HIGH-PERFORMANCE WIRELESS HANDHELD / LAVALIER TRANSMITTER [2+1]QTY.
[SHURE , AKG -MAKE]
Audio Frequency bandwidth
70 to 20000 Hz
Signal to Noise
105 dB-A
THD at 1 kHz
.8 Prozent
Operating temperature range
-10 to 55 Celsius
Peak deviation
45 kHz
Switching bandwidth
30 MHz
Recommended simultaneous channels
5
Number of selectable frequencies
8 Fixed frequencies
Frequency Selection
Fixed frequency
Radio Range (Line of Sight)
30m
Wireless channels within device
Switchable RF Power
Modulation
FM
Encryption
No encryption
Nominal deviation
15 kHz
Batterie type
LR6 AA alkaline battery
Operating Time
7h
Multi Purpose Mixer [1]qty. [Sound Craft, Sonodyne Make]
Frequency Response Mic / Line Input to any Output
T.H.D. Mic Sensitivity -30dBu, +14dBu @ Mix output
Noise Mic Input E.I.N. (maximum gain)
Aux, Mix and Masters (@ 0dB, faders down)
Crosstalk Channel Mute
(@ 1kHz) Aux Send Pots Offness
EQ HF
(Mono inputs) MF (swept)
LF
Q
. +/-1.5dB, 20Hz – 20kHz
< 0.02% @ 1kHz
-127dBu (150source)
< -85dBu
> 96dB
> 86dB
12kHz, +/-15dB
150Hz – 3.5kHz, +/-15dB
80Hz, +/-15dB
1.5
EQ HF
(Stereo inputs) MF (EFX Only)
LF
Q (MF)
Power Consumption
Operating Conditions Temperature Range
Input & Output Mic Input
Levels Line Input
Stereo Input
Mix Output
Headphones (@150)
Input & Output Mic Input
Impedances Line Input
Stereo Input
Outputs
AMPLIFIER
12kHz, +/-15dB
720Hz, +/-15dB
80Hz, +/-15dB
0.8
Less than 35W
5°C to +40°C
+15dBu max.
+30dBu max.
+30dBu max.
+20dBu max.
300mW
2k
10k
65k(stereo), 35k(mono)
150(balanced), 75(unbalanced)
[2] QTY. Crown , Australian Monitor, Quest Make
Performance
Sensitivity (for full rated power at 4 ohms):
1.4 Vrms.
Frequency Response
(at 1 watt, 20 Hz to 20 kHz): +0 dB, –1 dB.
Signal-to-Noise Ratio
Rated as dBr to full rated 8 ohm power output (A-Weighted):
XLS 1000 > 97 dB XLS 1500, XLS
Total Harmonic Distortion (THD):
< 0.5%.
Intermodulation Distortion (IMD):
(60 Hz and 7 kHz at 4:1)from full rated
output to –30 dB: < 0.3%.
Damping Factor (8 ohm) 10 Hz to 400 Hz:
>200.
Crosstalk (below rated 8 ohm power):
At 1kHz: > 85dBAt 20kHz: >55dB
Input Impedance (nominal):
20 kilohms balanced, 10 kilohms
unbalanced.
Load Impedance:
2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge
Mono.
AC Line Voltage and Frequency
Configurations Available (±10%):
120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 and 240 VAC 50
Hz.
Controls
Level: Two front-panel rotary level controls, one for each channel.
LCD Screen: Back-lit LCD allows for crossover configuration, amp
mode configuration and clip compressor configuration.
Menu/Prev/Next: Three buttons located near the LCD screen that are
used to configure and access the integrated processing.
Power: Front-panel switch; on when in the IN position. Blue LED will
illuminate when on.
Circuit Breaker: Back-panel breaker provides overload protection.
ACCESSORIES & HARDWARE [ JBL, Karemer, Clotz, Chtn Make]
Bracket for Suspending Speaker
[04]qty.
Patch Cord (for system interconnect
High grade , professional , low-noice, 2core high conductivity cable , pvc insulated in PVC electric,
shielded, copper cable with di-electric insulator with XLR male / female connector/ ep/jacks/
rca jacks
MOUNTED SCREEN WITH FULL HD-SIZE 8 X 6 FEET-
1 NOS
WIRING SYSTEM
Speakers Lines 80/2, ATC Twin twisted PVC Insulated cable in existing conduits
[150Mtr]
Microphone Lines 23/0.2 ATC copper shielded PVC insulated cable laid in existing conduits[150Mt]
VGA Cable Full HD Resolution
[25Mtr.]
HDMI Cable Karemer 1.4V
[25Mtr.]
Female XLR (Panel Mount)
[10]
Loudspeaker speakons
[10]
4 In 2 Out HDMI , VGA Switcher / Splitter
[01]
30U Rack with power indicator, power sockets and isolator fitted duly prewired to accommodate
control room equipment e.g. amplifiers, controller, equalizer
[01]