CNT 102
Cisco CNT 102 Required Exercises
Instructions
Required exercises for Cisco.netacad.net. Please submit a Printout of the lab. You may work on
actual equipment or use packet tracer (experience varies with packet tracer), but you will be
performing the same lab, please indicate weather you used lab equipment or packet tracer by your
name.
You may work in teams of two or three, but each person is to submit his/her individual work. It is
recommended that you submit labs by the following class. All work will be graded by the day of the
final exam. Some exercises may require additional time, so there is time built into the class
schedule to accommodate this. Exercises will be accepted up to the final exam without any penalty,
but I require time to properly grade the labs. Labs are graded as either Pass which indicates that a
majority of the concept has been accomplished or “redo” which indicates you have the option to resubmit the work for credit.
Note: Only a portion of the exercises are assigned; however, if you have the time and ability you are
encouraged to complete all the exercises.
Chapter 1
1.5.1: Cabling a Network and Basic Router Configuration(.pdf 4.0)
Hint: When in class the serial cable (COM1) access is available through the patch panel
and HyperTerminal is installed on the PC’s.
Chapter 2
6.1.6: Configuring Static Routes (.pdf version 3.1.1)
Chapter 3
4.1.4 Creating a Network Map using CDP (.pdf version 3.1.1)
Chapter 4
4.6.1: Routing Table Interpretation Lab (.pdf version 4.0)
Chapter 5
5.6.1: Basic RIP Configuration, do only Scenario A: Running RIPv1 on Classful Networks
(.pdf version 4.0)
Chapter 6
6.4.4: Basic Route Summarization(.pdf version 4.0)
Page 1 of 2
CNT 102
Chapter 7
7.5.1: RIPv2 Basic Configuration Lab (.pdf version 4.0)
Chapter 8
8.4.2: Show IP Route Challenge Lab (pdf version 4.0)
Chapter 9
9.6.1: Basic EIGRP Configuration Lab only through task 11 (.pdf version 4.0)
Chapter 10
No exercises
Chapter 11
Lab 11.6.1: Basic OSPF Configuration Lab (.pdf version 4.0)
Optional labs time permitting
3.2.9 Exercise: Backing Up Configuration Files
4.2.2 Exercise: Establishing and Verifying a Telnet Connection
4.2.3 Exercise: Suspending and Disconnecting Telnet Sessions
5.1.3 Exercise: Using the boot system Command
5.1.5 Exercise: Troubleshooting Configuration Register Boot Problems
5.2.5 Exercise: Managing IOS Images with TFTP
Figure 1 Packet tracer 2.7.3, NAME HERE, DATE HERE
Page 2 of 2