Associate in Science (A.S.) – Pre-Major in Engineering Degree – A1040D
Recommended Courses Checklist
Name:______________________________________________________
ID #:__________________________________
Before you can register for classes each semester, you must see an advisor at the College Transfer Advising Center.
The AS premajor is a general academic plan; you should base your individual decision for course selection on the
requirements of your specific engineering major at your preferred 4-year university.
-
Course Requirements: General Education Core
I.
II.
Total
Credit Hours
Composition……………………………………………………..
ENG 111 (required)
Select one of the following English
ENG 112 Argument Based Research
ENG 113 Literature Based Research
6
Humanities/Fine Arts…………………………………………..
Select one literature course: Literature courses are based on
time period and do not have to be taken in consecutive order
ENG 231, 232 American Lit I and II
ENG 241, 242 British Lit I and II
ENG 261, 262 World Lit I and II
9
Course Taken
ENG 111
(
)
ENG
(
)
ENG
(
)
(
)
(
)
(
)
(
)
(
)
Select 2 additional courses from 2 different subject areas:
ART 111, 114, 115, 116, 117
COM 110, 120, 231
(COM 231 Public Speaking recommended)
DRA 111, 112, 115, 122, 126
FRE 111 (and 181)
HUM 110, 115, 130, 160, 220
(HUM 110 is recommended)
MUS 110, 112, 113, 114, 213
PHI 210, 215, 220, 221, 240
REL 110, 111, 112, 211, 212
SPA 111 (and 181)
Read Foreign Language requirements for the University you
plan to attend.
Higher French or Spanish courses may be substituted if
placement warrants.
III.
Social/Behavioral Sciences…………………………………….
Select one history course:
HIS 111, 112, 121, 122, 131, 132
9
Select 2 courses from 2 different subject areas:
ANT 210
ECO 251 Microeconomics, 252 Macroeconomics
(One ECO course must be selected)
POL 110, 120, 210
PSY 150 (recommended)
SOC 210, 213, 220, 225
Associate in Science (A.S.) Pre-Major in Engineering A1040D 2009*03
Credit Hours
Received
Recommended Courses Checklist
HIS
Page 1 of 3
GENERAL EDUCATION CORE REQUIRED COURSES (CONT)
IV.
V.
Natural Sciences………………………………………………..
The following courses are required:
CHM 151
PHY 251 (pre-req MAT 271)
PHY 252
Mathematics…………………………………………………….
The following courses are required:
MAT 271
MAT 272
General Education Core Requirement
12
CHM 151
(
)
PHY 251
(
)
PHY 252
(
)
MAT 271
(
)
MAT 272
(
)
(
)
8
44 Semester Credit Hours
Other Required Hours and Electives
The courses you choose will depend on the 4-year College or university to which you plan to transfer and your specific field
of Engineering (your Engineering major at that university). Seek advising from: the College Transfer Advising Center
-
a transfer advisor at the university
Total
Credit Hours
VI.
Other Required Hours………………………………………….
Both of the following courses are required:
MAT 273 Calculus III
MAT 285 Differential Equations (pre-req MAT 271)
One of the following courses is required:
Must Take CIS 115 as Pre-req for the following
CSC 134 C++ (EE needs, Aero & ME (replaces FORTRAN))
Or
CSC 151 JAVA (Computer Science majors need to take)
One of the following courses is required:
CHM 152
DFT 170 (Solid Works good for any Engineering)
Course Taken
Credit Hours
Received
4
MAT 273
(
)
3
MAT 285
(
)
3
CSC (CIS 115 is
prereq; see below)
(
)
(
)
( 2
)
( 3
)
(
)
(
)
3-4
EGR 220 Statics (only for Civil, ME, Aero) (pre-req PHY 251)
If CHM 152 is not selected, then a minimum of 4 cr. hrs. in mathematics, natural
sciences, or computer science is also required in “Other Elective Hours” below.
VII.
Other Elective Hours…………………………………………...
Select the remaining 7 hours from the Other Electives List
below. If CHM 152 is not selected in “Other Required Hours” above, then
7
EGR 150
CIS 115
minimum of 4 cr. hrs. in math, natural sciences, or computer science is
required. Suggested courses below
CIS 115 Intro to Programming and Logic 3 credits
EGR 150 Intro to Engineering , 2 credits
equivalent to Introduction to Engineering
(Can take two PED XXX for 1 credit each to complete the 7
elective credits)
Total Graduation Requirement
Associate in Science (A.S.) Pre-Major in Engineering A1040D 2009*03
64 - 65 Semester Credit Hours
Recommended Courses Checklist
Page 2 of 3
Other AS-Pre-Major in Engineering Electives List
ACC 120, 121
ANT 210, 220, 221, 230, 230A, 240
ART 111, 113, 114, 115, 116, 117, 121, 122, 130, 131, 132, 140, 240, 244, 281
AST 111, 111A
BIO 111, 112, 120, 130, 140, 140A, 168, 169, 275
BUS 110, 115
CHM 152, 251, 252
CIS 110, 115
COM 110, 111, 120, 130, 231, 232, 233, 251
CSC 120, 130, 134, 136, 151
DFT 170
DRA 111, 112, 115, 120, 122, 124, 126, 128, 130, 131, 140, 141
ECO 251, 252
EDU 216
EGR 150, 210, 211, 212, 213, 220, 225, 228, 230
ENG 111A, 125, 126, 231, 232, 234, 241, 242, 253, 261, 262, 271, 272, 273, 274, 275
FRE 111 and 181, 112 and 182, 211 and 281, 212 and 282
GEL 113, 120, 230
HEA 110, 112
HIS 111, 112, 117, 121, 131, 132, 161, 162, 167, 216, 221, 222, 223, 226, 236, 251, 252
HUM 110, 115, 130, 160, 161, 170, 220, 230
JOU 110
MAT 151/151A or 155/155A, 167/A, 280
MSI 110, 120, 210, 220
MUS 110, 111, 112, 131, 132
PED 110, 121, 128, 130, 138, 139, 143, 175, 176, 177
PHI 210, 215, 220, 221, 230, 240
POL 110, 120, 130, 210
PSY 150, 237, 239, 241, 246, 259, 263, 281
REL 110, 111, 112, 211, 212
SOC 210, 213, 220, 225, 242, 252
SPA 111 and 181, 112 and 182, 211 and 281, 212 and 282
NOTES: Every type of Engineering has specific courses that are recommended or required.
Aero = Aerospace Engineering
EE = Electrical Engineering
CE - Computer Engineering
ME = Mechanical Engineering
1. Mechatronics - joint degree of Electrical and Mechanical Engineering, available at UNC Asheville as a transfer
student
2. Biomedical engineers can take Biology, Organic Chemistry I and II at Wake Tech. Make sure these courses transfer
to the University that you transferring to.
3. Start Physics or Calculus at Wake Tech finish at Wake Tech. Start Physics or Calculus at other college finish at
other college.
4. Check your transfer college requirements for Art, Drama or Journalism. Some Colleges of Engineering require
specific courses or will not transfer these courses to your major.
5. East Carolina University – undergraduate degrees in Systems Engineering, Bioprocesses, Biomedical Engineering,
Engineering Management.
6. NC A&T - undergraduate degrees Civil, Architecture, Bioenvironmental, Computer Science, Computer and
Engineering Electrical Engineering, Industrial and Systems Engineering, Mechanical and Chemical Engineering
7. NCSU - all types of Engineering are available.
8. UNC Charlotte – undergraduate degrees in Civil, Environmental, Electrical Computer, Mechanical and
Engineering Science
For specific questions about Engineering and Engineering University transfer options
Contact
Susan Meardon Dept Head for Pre-Engineering
919.866.5344
slmeardon@waketech.edu
This Checklist Is For Advising Purposes: Only The Registrar Can Clear Students For Graduation.
If this is your last semester and you are graduating you must complete an Application for Graduation with the Registrar.
Associate in Science (A.S.) Pre-Major in Engineering A1040D 2009*03
Recommended Courses Checklist
Page 3 of 3