Proceedings of the 4th International Conference on Nanomanufacturing (nanoMan2014)
8 – 10 July, 2014 ， Germany
First Author 1 , and Others 2
1 Full postal address of first author, including country
2 Full postal address of others author, including country
{Identify the corresponding author with an asterix }
*corresponding author (email: id@aaa.bbb.cc;)
Every author, whose abstract has been accepted for nanoMan2014, is required to submit a full paper. Papers presented at nanoMan2014 will undergo a normal stringent peer review process. All accepted papers will be published in the conference proceedings. Authors are requested to strictly adhere to the following guidelines in preparing their full paper(s). Selected papers will be published as a special issue in International Journal of
Nanomanufacturing (IJNM) .
Please exactly follow the format given in this template. Improperly formatted full papers might not be accepted for the proceedings. You can just simply overwrite this contents in the template.
Please submit your full paper online through the website www.nanoman2014.net/conference/#submission in
PDF and MSWord format by April 4, 2014 . If you have any question, please feel free to contact oriemer@lfm.uni-bremen.de
or christian.robert@lfm.uni-bremen.de
. Please note that one registration per accepted manuscript is required for inclusion in the conference program and proceedings.
Thank you for your understanding, cooperation and contribution. We are looking forward to seeing you at the conference.
: Keyword 1, Keyword 2, … (3- 5 Keywords) Please, choose the keywords from the official CIRP unified keyword list . One own keyword is feasible.
For the full manuscript, 4 pages for normal contributed papers and up to 6 pages for invited papers are required to be included in the conference proceeding. All margins 2.54 cm (1 inch), with header and footer of 1.78 cm (0.7 inch). Indent the first line of each paragraph 0.51 cm (0.20 inch) from the left margin. The full text using Times
New Roman 10 pt with single line spacing, unless otherwise stated for the title and headings.
Depending on the nature of the work, the full paper may contain common main headings e.g.
Introduction, Materials and Methods, Results and
Discussion, Conclusion and References.
Arabic numbers should be used for all Figures,
Tables, Equations and References.
2.1
Figure, Graph, Photo, Diagram, Table, etc.
All figures, photographs, diagrams and tables should be rich in contrast and should be placed as close to their 1 st citation in the text. Centre captions preferably directly below the Figure being described, and above the Table being described.
Provide one line space between text body and figures or tables.
3500
3000
2500
2000
1500
1000
500
Event 2 Event 3 Event 1
250
200
0
0 5 10 15 20 25 30 35 40 45 50 55 60 65
0
Time (minute)
150
100
50
Fig. 1: Figure Title

Proceedings of the 4th International Conference on Nanomanufacturing (nanoMan2014)
8 – 10 July, 2014 ， Germany
Water supply and Sanitation, 20 th WEDC
Conference. Proc. pp. 297-299, 1994.
[3] C.D. Cornell and U.T. Kaplan. “Sources of energy.” Elsevier, pp. 125-134, 2003
Table 1: Table Title
Parameter
Concentration
(mg/L)
Loading
(kg/m 3 )
Remarks
BOD
TSS
35
70
2.44
4.88
High
Low
2.3 Equations
Equations and symbols should be written using
Microsoft equation editor. Equations should be referred in the text as Eq. (1), Eq. (2) and so on.
Use only one Tab space between equation and its number. rate

Wqk f

 a
IB a
MeOH
 a
MTBE
K eq a
MeOH
2


(1)
Use Arabic numerals and standard abbreviations for all measurements. Use units of measurement consistently within the text and tables. Measurements are to be expressed in SI
(metric) units. Abbreviations must be written in full at their first citation.
List the cited references at the end of the text with Arabic numerals (1, 2, etc.) with the order they appear in the text. Cite references in the text using [1], [2] and so on. A few formats are given below:
[1] S. A. Muyibi and L. M. Evison. “Optimizing physical parameters affecting coagulation of turbid water with Moringa oleifera seeds.”
Water. Res. Vol.29, No.12, pp. 2689-2695,
1995.
[2] J. P. Sutherland, G. K. Folkard and W. D.
Grant, “Moringa oleifera as a natural coagulant”. In Pickford et al. Eds. Affordable