Name: _________________________
AGEN 161
Flow and Velocity Lab
Each part of the lab will include the following and will be handed in:
Calculations page showing each step
Typed Conclusion: a few paragraphs explaining what was done with this experiment
and what can be concluded from it.
Use the following schematic for Part I
Part I
Calculate the flow rate (in GPM) of the pump of the Vickers Test Stand
Piston Diameter
_________
Piston Area
___________
Rod Diameter
_________
Rod Side Area
___________
Piston Side Volume
_________
Rod Side Vol.
___________
Stroke
_________
Extension Time
_________
Flow Rate Piston Side
Retraction Time
___________
Flow Rate Rod Side
___________
Fluid Velocity on Piston Side
___________
Fluid Velocity on Rod Side
___________
Use the Following Schematic for Part II
0.00 GPM
___________
Part II
Fill in the following information for each cylinder of the Hampden Test Stand
Flow (GPM)
_______________
Piston Diameter __________________
Stroke
_______________
Rod Diameter
__________________
Extension Time _______________
Piston Area
__________________
Retraction Time _______________
Rod Side Area
__________________
Velocity Extension
Velocity Retraction
_______________
_______________
Part III
Fill in the following information for the bucket of the Caterpillar 248B
Flow (GPM)
_______________
Piston Diameter __________________
Stroke
_______________
Rod Diameter
__________________
Extension Time _______________
Piston Area
__________________
Retraction Time _______________
Rod Side Area
__________________
Velocity Extension
Velocity Retraction
_______________
_______________
Part IV
Fill in the following information for the loader circuit of the Caterpillar 248B
Flow (GPM)
_______________
Piston Diameter __________________
Stroke
_______________
Rod Diameter
__________________
Extension Time _______________
Piston Area
__________________
Retraction Time _______________
Rod Side Area
__________________
Velocity Extension
Velocity Retraction
_______________
_______________
278-1969 - CYLINDER GP-HYDRAULIC
278-1969 CYLINDER GP-HYDRAULIC -BUCKET
S/N LBA1-UP; SCL1-UP
60-MM (2.4-IN) BORE X 200-MM (7.9-IN) STROKE
PART OF 154-5004, 154-5008, 154-5010, 199-8320, 279-5382, 279-5390, 279-5398, 279-5403, 3257036, 325-7046, 325-7056, 325-7066, 325-7076 BUCKET AR-MULTIPURPOSE
AN ATTACHMENT 01/06/2012
230-3685 - CYLINDER GP-LIFT
230-3685 CYLINDER GP-LIFT -LH
S/N SCL1-UP
60-MM (2.4-IN) BORE X 715-MM (28.2-IN) STROKE
PART OF 218-5799 CYLINDER & MTG GP-LIFT