Pointe Guard 9005 - Cutting Edge Fluids

advertisement
Material Safety Data Sheet
Identity: POINTE GUARD ,POINTE GUARD MC, PREMIUM SOLUBLE OIL
Section I
Manufacturer: Cutting Edge Fluids, Inc.
Address: 777 Canterbury Rd.
Westlake, OH 44145
Emergency Telephone Number: (440) 899-6340
Information Telephone Number: (440) 899-6340
Date Revised: 1/02/07
HMIS Ratings:
NFPA Ratings
Health:
Fire:
Reactivity:
Personal Protection:
0
1
0
B
Health
0
Fire
1
Spec. Haz.
0
Reactivity
0
SECTION II - Hazardous Ingredients/Identity Information
CAS number
Component__________________
64742-52-5
Mineral Oil
%
< 60
PEL
10mg/m3
SECTION III - Physical/Chemical Characteristics
Specific Gravity (H2 o=1)
N/D
>212F (100C)
Vapor Pressure (mm Hg)
N/A
Melting Point
N/A
Vapor Density (Air = 1)
N/D
Evaporation Rate (Butyl Acetate = 1)
Solubility in Water
Dispersible
Appearance and Odor
Medium brown with a mild oily odor
Boiling Point
N/D
SECTION IV - Fire and Explosion Hazard Data
Flash Point (Method Used)
Extinguishing Media
will float.
Flammable Limits
LEL:
N/D
UEL: N/D
255F (TCC)
Dry chemical, CO2, foam and water fog. No water stream, some of product
Material is not a fire hazard, but will burn at high temperatures. Do
not enter confined fire-space without full bunker gear(helmet with face shield, bunker coats,
gloves and rubber boots), including a NIOSH-approved positive pressure self-contained breathing
apparatus. Cool fire exposed containers with water.
Unusual Fire and Explosion Hazards
none noted
Special Fire Fighting Procedures
SECTION V - Reactivity Data
Avoid heat, open flames and
ignition sources.
Incompatibility (materials to avoid) Strong oxidizing agents. Do not use with nitrites.
Hazardous Decomposition or by-products Hydrogen chloride, Oxides of carbon & sulfur.
Hazardous polymerization
Will not occur
Stability
Stable
Conditions to avoid
SECTION VI - Health Hazard Data
Route(s )of Entry
Primarily by way of eyes and skin
Health Hazards (Acute and Chronic) :
The following Toxicological assessment is based upon data from the following toxicity tests: eye irritation, skin
irritation, ames mutagenicity assay, mouse micronucleus cytogenetic assay and 28 day repeated dose oral
toxicity.
Eyes:
Will cause irritation on contact, may be severe if not immediately removed.
May cause mild irritation on contact. Prolonged of repeated contact may cause drying,
defatting of skin and dermatitis. An ingredient in this product may be absorbed through the skin.
Skin:
Inhalation of vapors (generated at high temperatures) or oil mist from this product may
cause mild irritation of the upper respiratory tract.
Inhalation:
Ingestion: Will
cause nausea, vomiting and diarrhea if ingested but has a low order of toxicity.
Signs and Symptoms of Exposure:
Eyes:
Irritating to eyes upon contact, may be sever if not immediately removed.
Skin: Short
term exposure: Slight localized and transient eczema. Long term Exposure: May lead
to dermatitis, oil acne or folliculitis.
Inhalation:
Ingestion:
Mist may irritate mucous membranes. At high temperatures irritation is pronounced.
Will cause nausea, vomiting and diarrhea.
Medical Conditions generally aggravated by exposure:
none noted
Emergency and first aid procedures:
Eyes:
Wash with copious amounts of water for at lead 15 minutes. Seek medical attention.
Wash exposed areas with soap and water. Seek medical attention immediately. Do not
reuse clothing soaked with this product until laundered. Discard all leather articles which have
been soaked with this product.
Skin:
SECTION VII - Precautions for Safe Handling and Use
Shut off the source of the leak if it is safe to do
so. Dike and contain the spill. Remove with vacuum trucks. Soak residue with clay, sand or other
suitable materials.
Waste disposal method: Dispose of the contaminated absorbent material properly.
Precautions to be taken when handling and storing: Avoid exposure to skin and eyes. Wear protective
clothing.
Other Precautions:
N/A
Steps to be taken in case material is released or spilled:
SECTION VIII - Control Measures
NIOSH approved self contained breathing apparatus.
Ventilation: local exhaust
Protective Gloves: nitrile gloves
Eye Protection: NIOSH approved safety goggles.
Other Protective Clothing or Equipment: unnecessary.
Work/Hygienic Practices: Clean up spills immediately.
Respiratory Protection :
Download