1
A BC FIRSTAUTHOR,
1
D EF SECONDAUTHOR AND
2
H IJ THIRDAUTHOR
1
D
EPARTMENT OF
X
XXXXX
E
NGINEERING
, Y
YYYYY
U
NIVERSITY
2 X
XXXXX
I
NSTITUTE OF
T
ECHNOLOGY
1
12-34 Abcdfg, Hijklmn, Nagoya 123-8888
，
Japan
2
568-8 Gfdcba, Nmlkjih, Tokyo 456-9999
，
Japan phone: +81-**-***-****, fax: +81-**-***-**** e-mail: firstauthor@***.***.ac.jp
Title, Author(s), Affiliation(s), and contact address are writen in single colummn.
1. Introduction Only online submission via the Symposium
This leaf presents instructions for preparing one-page abstracts to be included in the abstract book of ISPLasma2010. The set of instructions is given in the style and format to be used by the website (http//www.isplasma.jp ) will be accepted, NO LATER THAN November 6,
2009 .
authors.
2. General Instructions
Please use A4-size (210mm x 297mm) white bond paper and set top and bottom margins to
25mm, left and right margins to 17mm. Both text and figures must fit inside this area as indicated by this sample. Each abstract will be printed out in reduced size, including the presentation number.
Please use font type of Times New Roman (or similar fonts, with single spaced lines. It is possible for the title of the paper (14 points, first letters caps) to span a maximum of two rows, followed by one blank line. Author’s names should be written (12 points) with initials followed by dot, with family names written in full. When necessary to distinguish authors from different affiliations, they should be separated by commas and marked with superscript. The presenting author’s name should be underlined.
Author’s affiliations (12 points, italic) should be written in separate rows when there are several authors, followed by two blank lines. Abstract text (12 points) is justified at two sides; paragraphs are to be indented, and each section is to be separated by one blank line. References should be listed at the end of the paper with square brackets (12 points) [1-3].
3. Submitting the Abstract
Figure 1. ISPlasma2010 (Font for figure caption is 10pt)
5. Conclusions
The acceptance will be informed by the end of December 2009 with the instructions for submitting papers to the special issue of JJAP .
Acknowledgments
It is our pleasure that we could meet you in
ISPlasma 2010 and discuss collaborations between industry and universities about advanced plasma science and technology.
References
[1] A. Bcdeasdf, F. Ghijk, L. Mnop, Q. Rstu and
V. Wxyz: Appl. Phys. Lett. 71 , 2067 (19xx).
[2] Z. Yxwv, U. Tsrq, P. Onml, K. Jihg and E.
Dcba: Inst. Phys. Conf. Ser. No. 145 (19xx) p.
000
[3] A. C. Egij, Jr. and L. N. Prtv: Heterostructure
Lasers (Academic Press, New York, 200x),
Part B, p. 71.