Southwest Clean Air Agency
Page 1 of 2
Veneer Driers
Manufacturer name
Model name
Model number
Serial number
Year constructed
_____________________________________________________
_____________________________________________________
_____________________________________________________
_____________________________________________________
_____________________________________________________
Number of Driers:
Type: (1) Longitudinal
(2) Jet
(3) Other (Specify)
_________________
_____________________________________________________
Energy Source (fuel):
(1) Hog fuel
(2) Natural Gas
a. Number of Burners ______________________
b. Size __________________________________ (Btu/hr each)
Steam Heated? _________________________
Rate: ____________ (lb/hr)
Total Number of Zones: _______________________________________________________________
Total Number of Sections: _____________________________________________________________
Sections
Height
Width
Depth
Infeed Sections
Cleaning
Drying
Cooling
Outfeed
Overall Length of Drier: _____________________________
Number of Decks: __________________________________
Size and Spacing of Rolls: _______________________________________________________________
_____________________________________________________________________________________
Operation Time of Dryer:
_________hrs/day
_________days/week
_________weeks/year
SWCAA Form No. 50
8/8/00
Southwest Clean Air Agency
Page 2 of 2
Raw Materials:
Specie & Thickness
Sq. Ft./year
(3/8” basis)
Drying Time
Sapwood
Heartwood
White Speck
Sapwood
Heartwood
White Speck
Sapwood
Heartwood
White Speck
Sapwood
Heartwood
White Speck
(If additional room is needed, please attach an additional page.)
Dry moisture content (after veneer leaves dryer): _____________________________________________
Number of Blowers: ___________________________
Horsepower (each): ____________________________
Rated CFM: __________________________________
Minimum Exhaust Stack CFM: __________________
Damper setting ________________ (% open)
Maximum Exhaust Stack CFM: __________________
Damper setting ________________ (% open)
Number of Exhaust Stacks and Where Located: ______________________________________________
_____________________________________________________________________________________
Other Exhaust Systems on Dryer (Describe): ________________________________________________
_____________________________________________________________________________________
Diameter of Stacks: ___________________________
Height of Emission Points: _____________________
Drier Temperature: ___________________________
Point Where Temperature is Monitored: ____________________________________________________
SWCAA Form No. 50
8/8/00