(1cm) MODEL AND INSTRUCTIONS FOR PREPARING AN ABSTRACT
FOR EKE3 2006. (write the title in bold and capital letters)
Leave one line blank
M. Trechagirevopoulos1, O. Eponymos2, and E. Eponomazomenos2
1
Institute of Materials Science, NCSR “Demokritos”, 1510 Agia Paraskevi, Attiki,
Greece; 2 Department of General and Inorganic Chemistry, Faculty of Chemistry,
Aristotele University of Thessaloniki, 54124 Thesaloniki, Greece
Leave one line blank
This page is a model of presentation of your abstract (plenary, invited, oral or
poster). The abstract has to be written in English. Since the abstracts will be
directly reproduced in a volume to be distributed to the participants, please follow
carefully this format and the instructions. Figures are allowed in the abstract. All
the text should be justified left and right. The title should start at 1 cm from the
frame; it should be all caps and bold, Times size 12, single-spaced. The
presenting author should be underlined. Authors’ names should be reported with
the initials, as in the example and with a number superscript to indicate the
Institution. The Institutions’ addresses should start on the following line. The
body of abstract should be typed in Times size 12, single-spaced and must fit into
this frame with top margins of 2.5 cm, bottom margin of 2.5 cm, left margin of 4
cm and right margin of 3 cm, for a standard A4 paper size (total text width 13.5
cm, total text length 1 page maximum). References [1], typed in Times size 12,
single-spaced, should appear at the end of the text and should be no more than 2
for each abstract. Please
comply with these requirements, especially that of
maximum length, because this will help us in the preparation of Conference
Book of abstracts. The abstracts must be submitted prior to the deadline 5
September, 2010.
Leave one line blank
[1] S. Stuart et al. Phys. Rev. B 60 (1999) 3320
[2] P. Morris et al. Phys. Rev. Lett. 70 (2000) 214