MUSWN Wireless Optical Mouse
USER MANUAL
MUSWN Wireless Optical Mouse
USER MANUAL
Disclaimer
 We spared no efforts to make sure that the information in this
manual is correct and complete. However no liability is accepted for any
errors or omissions. Gembird Electronics reserves the right to change the
specifications of the hardware and software described in this manual
without prior notice.
 No part of this manual may be reproduced, transmitted or translated
in any language in any form, by any means, without the prior written
permission of Gembird Electronics Ltd.
 Gembird Electronics makes no warranties for damages resulting
from corrupted or lost data due to a mistaken operation or malfunction of
the product, the software, personal computers or peripheral devices.
Gembird® is a registered trademark of Gembird Europe bv.
Other names or products not mentioned above may be registered
trademarks or trademarks of their respective owners.
Copyright © 2009 Gembird Electronics Ltd. All rights reserved
GEMBIRD EUROPE B.V.
http://www.gembird.eu
2
MUSWN Wireless Optical Mouse
USER MANUAL
Features




Wireless optical mouse with USB receiver
The tiniest receiver in the world can be stored inside the mouse
Smart power saving provides extra long batteries life
Special button for switching the resolution 800/1600 DPI
Specifications
 Wireless technology: 2.4 GHz, FSK RF modulation, 48 channels,
16 bit device ID, RF power < 2 mW
 Operating distance: up to 8 m
 Optical resolution: 800 or 1600 DPI selectable by the button
 Power supply: AAA battery x 2 pcs
 Power consumption: < 18 mA, saving modes < 2.5 mA and < 0.5
mA, up to 55 hours continuous work with 1000 mAH batteries
 Nano receiver: USB 1.1 compatible, weight 2 g, 6 x 14 x 21 mm
 Mouse: dimensions 94 x 61 x 37 mm, net weight 57 g (without
batteries)
 Operating conditions: -5...40 Celsius degrees, 20-90 % humidity
GEMBIRD EUROPE B.V.
http://www.gembird.eu
3
MUSWN Wireless Optical Mouse
USER MANUAL
Installing the Batteries
The MUSWN optical mouse uses two AAA alkaline batteries.
To install the Batteries into the mouse please do the following:
Step1. Open the battery compartment.
Step2. Insert the batteries as shown on the picture below inside the
battery compartment.
Step3. Close the cover.
GEMBIRD EUROPE B.V.
http://www.gembird.eu
4
MUSWN Wireless Optical Mouse
USER MANUAL
Connecting with Receiver
USB Port
Receiver
1.Insert the USB plug of the receiver into USB port of your computer
Receiver
USB Port
GEMBIRD EUROPE B.V.
http://www.gembird.eu
5
MUSWN Wireless Optical Mouse
USER MANUAL
CAUTION
Windows 98 may require a prior USB port driver installation.
1. Whenever you’d like to use the mouse, you should pull out the
receiver from the bottom part of the mouse and insert it to the USB port
(see the figure 1 below).
2. Whenever the mouse is not in use you can store the receiver in a
special slot at the bottom of the mouse (see the figure 2 below) – so the
receiver will not be lost.
GEMBIRD EUROPE B.V.
http://www.gembird.eu
6
MUSWN Wireless Optical Mouse
USER MANUAL
Software Installation
Insert supplied CD with software into the computer CD-ROM drive,
then follow the on-screen instructions. The CD will start automatically (if the
auto-run function is enabled). Otherwise you can start installation manually
by clicking the “setup.exe” file.
An icon of the mouse will appear in the Windows system tray after
successfully completing the software installation.
Mouse icon in the system tray
GEMBIRD EUROPE B.V.
http://www.gembird.eu
7
MUSWN Wireless Optical Mouse
USER MANUAL
You can double click or right click over the icon to adjust the mouse
settings.
Power-Save function
This mouse is equipped with Traveling-Power-Save function.
Whenever the receiver is disconnected from the PC the LED of the
mouse will be switched off automatically to save the battery.
Whenever the mouse is not used for 8 seconds it will fall into sleep
state. To wake the mouse up just click any button or rotate the wheel.
Restoring factory default settings
You can restore the factory default settings. To do so please do the
following:
1. Check whether the batteries are fully charged; if the batteries are
dead, please replace them with the new batteries.
2. Press the right button and the middle button (the scrolling wheel)
at the same time.
3. Insert the receiver in the USB port of your PC.
GEMBIRD EUROPE B.V.
http://www.gembird.eu
8