Color Wash
CW-36
User Guide
Advanced LED Technology
1-
Color Wash 36 is an extremely powerful and robust architectural color changer. With
state of the art RGB color mixing technology, stylish housing, high output , IP65 rated,
and optimal thermal management, it is ideal for both interior and exterior architectural
lighting applications.
1. Attention:
- Do not install the fixture near high inflammable liquids or materials.
- Do not allow anything to rest on the fixture.
- Do not install the fixture near the naked flames.
- Do not install the fixture in dirty, dusty or badly ventilated location.
- Do not looking directly into the LED light beam at close range.
2. Technical specifications:
Compatible Power Supply: V Power 60/120/240/600
Number of LEDs: 12R, 12G, 12B or 36CW or 36WW
Available LED Colors: RGB, CW, WW
LED Life Expectancy: 50,000hrs
LED Emitter: 1W
Input Voltage: DC 48V
Max. Input Current: 350mA
Power Consumption: 39.2W
Beam Angle: 15°, 25°or 45°
IP: 66
Size: 235 x 222 x 77mm
Weight: 4.0 kgs
2-
3. Installation
The Color Wash 36 unit should be connected to the V Power driver. See V Power 60( or
V Power 120, V Power 240, V Power 600) user manual for full details of mains power
requirement, built-in programs and DMX operation. Connect the end of the Color Wash
36’s cable directly to the driver or use suitable cable joint box (V-JB (option), water-proof
for outdoor installation) if the cable has to be extended.
The RJ45 plug that connects the Color Wash 36 unit to the V Power driver has the
following wiring:
RJ45 plug
(View facing pins)
3-
PIN
Color of wire
RGB
1
White/Orange
Not used
2
Orange
Red LED +
3
White/Green
Blue LED +
4
Blue
Green LED +
5
White/Blue
Not used
6
Green
Red LED -
7
White/Brown
Blue LED -
8
Brown
Green LED -
4.Change Beam Angle
In this CW-36 series, if you want to change the beam angle of fixture, you can change
lens of the fixture refer to the photo below:
5. Maintenance
- Operate only in places where the sufficient air own to cool the module is present.
- Clean the front transparent cover at least every 1-2 months. Use a moist, lint-free
cloth. Never use alcohol or solvents!
4-