Instructions: Tool Oxygen Regulator (T.O.R.)
Removing the oxygen regulator:
1. Slide the T.O.R.’s valve stem opening over the oxygen bottles turn on/shut off valve.
2. Turn counter clockwise until the bottle is completely shut off.
3. Bleed oxygen by turning liter flow to its maximum flow rate. This should empty any residual
pressure left in the regulator’s cavity.
4. Place the T.O.R. in your dominant hand and lay the T.O.R.’s retainer pin over the oxygen
regulator’s butterfly stem. Turn counter clockwise until the pressure of the retainer screw loosens
up.
5. Manually remove the regulator.
Installing the oxygen regulator:
1. Place the oxygen regulator ensuring that it has an intact gasket on a fresh, filled bottle of oxygen.
2. Manually turn the butterfly stems to set the retainer screw in place.
3. Apply the T.O.R. manually and hand-tighten the butterfly stem to set the retainer screw properly
on the oxygen tank.
4. Attach the oxygen stem opening of the T.O.R. and turn the stem clockwise to the fully open
position. (The regulator gauge should register the proper PSI reading.) Shut the oxygen liter flow
knob.
Note: If the oxygen system leaks after following the instructions for installing the oxygen regulator,
repeat the steps for removing and installing the oxygen regulator. If the oxygen system still leaks,
follow your department guidelines for reporting and/or replacing malfunctioning equipment.
Care and Maintenance of the T.O.R.
The improper use of this tool can lead to equipment failure and or damage. Fire Medic Solutions follows
the oxygen regulator manufacturer recommendation to only hand-tighten the oxygen regulator to the
oxygen bottle. Please follow the instructions of the T.O.R. for proper use and continuous working order of
your equipment.
In the event that the T.O.R. becomes contaminated with blood, bodily fluids, or dirt, the T.O.R. can be
grossly decontaminated with soap and water, and then chemically decontaminated by using a 10% bleach
solution or your departmental approved cleaner/disinfectant. Allow to air dry before storing.
Made in the USA
Your T.O.R. is proudly made in the U.S.A. and comes with a lifetime warranty. Should the T.O.R. fail
due to manufacturer defect, simply send the unit back to us with the receipt of purchase. Include a brief
description of how the failure occurred and Fire Medic Solutions will gladly replace it
This warranty covers the use of the T.O.R within the guidelines of proper use. Any improper use or abuse
of the T.O.R voids its lifetime warranty. See instructions for use.
Fire Medic Solutions
Phone: 954.830.6776
Email: info@firemedicsolutions.com
Web: www.firemedicsolutions.com
2