Corrections and additions to FS7 User Manual
Notes
Attaching/detaching power source while Power Switch is ON
Always set the POWER switch to the OFF position before detaching or attaching a battery
pack or AC adaptor. If detaching or attaching batteries with the POWER switch in the ON
position, the camcorder may be unable to restart in some cases.
If the camcorder cannot be restarted, set the POWER switch to the OFF position and
temporarily remove the battery pack and/or AC adaptor, then wait about 30 seconds before
attempting to attach again.
It is possible to connect or disconnect the AC adaptor while the camcorder is operating from
battery power, or attach or detach the battery while operating from AC adapter without any
problem.
Use appropriate XQD card type
When performing Simultaneous Recording, insert XQD media in both A and B card slots that is
recommended for the recording format.
Recording Start Timing
If the record button is pressed within a few seconds after turning the camcorder ON, the
recording indicator lights up to indicate the unit is in the recording state, but recording to
media may not occur for the first few seconds, depending on the recording format selected.
Video Monitoring when using a Wireless LAN Connection
In the current version, the unit supports video monitoring only (when using the CBK-WA100).
Please replace the description provided on page 47 in “Connecting Devices using Wireless LAN”
as described above.
Video Signal Monitor Restrictions
Video Signal Monitor cannot be used if the SDI output is disabled.
Check the following settings:
 [Output On/Off] >[SDI] in the Video menu
 [Output Format] >[SDI] in the Video menu
Video Signal Monitor cannot be displayed under the following conditions:
 When [Output Setting] >[4K/2K to HD Conv.] in the Video menu is set to [Edge Crop]
 When [Monitor LUT] >[SDI1&Internal Rec], [SDI2], [HDMI], and [Viewfinder] in the Video
menu are set to mixture of [MLUT On] and [MLUT Off]