Cobalt Crush Bling Bracelet

advertisement
Cobalt Crush Bling Bracelet
by Mykeall Shepherd for Halcraft USA, Inc.
Rating: 2 stars: stringing & crimping
Time: 1.5 hours
Materials:
10288428
10290821
?????????
5 - Bead Gallery® Shiny mix acrylic rondel
20 - Bead Gallery® Sapphire acrylic rondel mix
12 - Bead Gallery® Silver spacer bead
Bead Landing silver 4mm jump rings
Bead Landing silver crimp tubes with loop
Bead Landing silver clasp closure
20" silver .018"49-strand Beadalon flexible beading wire
Tools:
Round-nose pliers
Chain-nose pliers
Wire cutters
Instructions:
1. Gather the shiny mix acrylic rondel beads, the sapphire acrylic rondel mix beads, silver
spacer beads, and the beading wire. Thread 1 silver spacer bead, 1 sapphire acrylic rondel
mix bead, 1 shiny mix acrylic rondel bead, and 1 sapphire acrylic rondel mix bead.
2. Repeat Step 2 four more times.
3. Now thread 1 silver spacer bead.
4. Using the Bead Landing crimp tubes with loop and the end strand, insert the end of the
beading thread into the crimp tube until it meets the hole of the loop. Using your chain
nose pliers, fold over both open edges of the crimp tube and press firmly. Make sure the
wire is held tightly with the crimp tube.
5. Repeat this crimp tube closure step on the remaining end and trim any access wire. Add a
jump ring through the loop of each crimp tube with loop.
6. Add a silver clasp closure to one of the jump rings.
7. Add a few more jump rings to the remaining jump ring on the other end of the bracelet.
Helpful tip: this will make the bracelet adjustable.
Download