Name ___________________________________ Due date ______________ Class section _______ Science Chapter 5: Deformation of the Crust Earth Science 12 pts Section 5.1: How the Crust is Deformed (p. 83-84) Multiple choice: Choose the one best response. Write the letter of that choice in the space provided. _____ 1. The bending, tilting, and breaking of the earth’s crust is called ___. a. isostasy b. faulting c. straining d. deformation _____ 2. Up and down motions of the crust are called ___. a. thrust faulting c. strain movement b. isostatic adjustments. d. compressional stress Short answer: 3. Identify 3 common locations where isostatic adjustments occur in the crust. _______________________________________________________________________ _______________________________________________________________________ _______________________________________________________________________ Section 5.2: The Results of Stress (p. 85-87) _____ 4. The permanent deformation of a rock without the rock breaking is called ___. a. collision b. folding c. faulting d. fracturing _____ 5. Rocks deeper in the earth’s crust are less likely to deform by breaking than rocks closer to the earth’s surface because of ___. a. lower stresses c. higher strains b. higher temperature d. lower altitude _____ 6. The footwall consists of rocks located ___. a. at the base of a cliff c. under a plate boundary b. below the fault plane d. along a transform fault _____ 7. Where do strike-slip faults often occur? a. at mid-ocean ridges c. between grabens b. in the lower half of the crust d. along transform fault boundaries Short answer: 8. What are the 3 general types of folds in rock deformation. ____________________________________________ ____________________________________________ ____________________________________________