NOR2 Layout Using Layout XL
This tutorial assumes that you have completed a basic layout tutorial
Below is the schematic that we will be creating a layout for.
Document1
bolson@csupomona.edu
2/8/2016
Page 1 of 5
1)
2)
3)
4)
5)
6)
7)
In the top toolbar select: Tools->Design Synthesis->Layout XL
In the new window select create new
Select OK to close the window
Select OK to close the new window
You will see a Virtuoso layout window
In the top toolbar of the new Virtuoso layout window select Design-> Gen from Source
Select a pin name (below vdd is selected).
o Change the pin Layer and width
o Select update to change the properties of the pin
8) Repeat for all the pins
9) The Boundary information (at the bottom of the window) is the area that you anticipate your layout
occupying
Area that you
anticipate
your layout
occupying
Document1
bolson@csupomona.edu
2/8/2016
Page 2 of 5
10)
11)
12)
13)
14)
Under Pin label options select roman as the font (it is easier to read)
Select OK at the top to close the window
In top toolbar of the layout Virtuoso window select Options->Display
Change the Display levels to stop at 10
Select OK to close the window
15) In the Virtuoso Layout window you will see the transistors and pins. They all must go in the
PrBound Box (the purple box)
pins
Document1
bolson@csupomona.edu
2/8/2016
Page 3 of 5
16) Move the transistors (bindkey m) into the Pr Bound box as shown below. You will have to merge sources
and drains by overlapping transistors. As you do this notice that lines appear indicating the connectivity
of the gate, source and drain of the transistors to the corresponding pins
17) Move the pins to correspond with the layout (as shown below). When you move the pins you are moving
text and a box (The box not visible until selected). Make sure that you select both.
o You may remember that the pins were originally assigned layers ex) A was assigned to ploy and
Y to metal 1. When the pins are placed on the layout they should be placed on those layers. If
not, change the pin layer by selecting the box that the pin is affiliated with and selecting bindkey q
to change the properties so that the layers agree
18) If you look at the virtuoso schematic window you will notice that when a transistor or pin is selected on the
layout then it is highlighted on the schematic.
Document1
bolson@csupomona.edu
2/8/2016
Page 4 of 5
19) Complete the layout of the nor2 as shown
Document1
bolson@csupomona.edu
2/8/2016
Page 5 of 5