Disassemble Chart (For Reference only. Models’ option may be varied by countries
2-1
2-2 Top I/O functions
檔名 : 部件位置說明
Accessory Box
Installation Guide
1. Open Chassis
1.1 Unscrew to remove both left and right panels.
2. Install Power Supply
2-1 Place the power supply into the chassis and secure with screws C. Face the power supply’s
Fan download towards the bottom case fan filter ti allow it to draw in cool air.
2-2. please check the PSU dust filter is installed securely in its’ location.
Notice: -Please remember to clean the PSU dust filter regularly.
3. Install Motherboard
3-1 Install motherboard stand-offs according to your motherboard’s form factor. Referring the
3-2 Place the motherboard onto stand-offs and secure with screw A.
Noted : NOT every motherboard is made by standard, please set stand-offs according to your
motherboards..
3-3 install the CPU , CPU cooler and DRAM modules
.
4. Install Add-in Card
4-1 Unscrew the thumb-screw to remove the expansion slot cover.
4-2 Install the add-in card.
4-3
Screw to secure the add-in card.(加個螺絲)
5. Install External 5.25” device
5-1. Take off the front bezel and remove the bay covers.
5-2. Install device from the front panel into the chassis and then secure with screw-less kits.
6. Install 3.5”HDD
6-1 take out removable HDD cage from chassis.
6-2 Put the 3.5” HDD onto the HDD cage and then secure with screws B.
6-3 Slide the HDD cage into chassis and then secure with screws.
7. Install 2.5” HDD/SSD
7-1 take out the 2.5” HDD tray from back of motherboard tray.
上圖移除 2.5” HDD
上圖移除 2.5”HDD 跟螺絲
7-2 put the 2.5” HDD/SSD onto HDD tray and then secure with screw
7.3 Secure the HDD unit back onto back of motherboard tray.
8. Connect top I/O & Fan Control cables
8-1 Please refer the illustration 8a to connect the front I/O cables to Motherboard
8a
9. System ready
9-1. Double check that all connectors are solidly connected to motherboard, add-in cards and the other
peripheral devices.
9-2. Close both side panels back and secure with screws
9-2. Computer system is ready.
10. Clean the dust filers
Star predator case has 2 dust filters located on top cover and chassis bottom. Each dust filter could be
released to clean the dust.
10-1 Refer to illustration 10a to take out the plastic rivets for removing the top dust filter.
10a 濾網的圖改在由內往外
10-2 Refer to illustration 10b to take out the dust filter net from chassis bottom for cleaning.
11. Install optional equipment.
Star predator has option to install additional fans on top cover or install a 240mm liquid cooling system
instead of front pre-installed fans.
11-1 Install an additional fans on top cover.
a. Remove the plastic rivets of top dust filter.
b. Install additional 120/140mm fans up to 2 on top cover and secure with screw.
11-2 Remove the front fans to install a 240mm liquid cooling system.
a. Take off the front bezel and remove the front fans.
c. Secure the fans onto outer of front panel and secure the radiator onto inner of front panel as
sandwich.
d. Put back front bezel back to chassis.