Preparation of your abstract for IEMT-EMAP 2016
Y.T. Lee1, A. Bennett2
1
2
Intel Technologies, Penang, Malaysia
Department of Mechanical Engineering, UTM, Malaysia,
A one-page abstract should be prepared in the following format: (1) Use a sheet of A4 size
paper. (2) Use 12 points Times New Roman for the main text and smaller fonts may be used for
figure captions. (3) The width of each line should not exceed 17.5 cm or 7.0 inch. (4) Start the
first line leaving the space of 2.5 cm or 1.0 inch on the upper side. (5) Title, author's names, and
affiliations should be centered. (6) Insert one blank line between the affiliations and the main
text. (7) Main text should be fully justified with a single spacing. (8) Use bold face with bigger
fonts for title but not for authors, affiliations, and the main text. (9) Please underline the
presenting author. (10) Leave the space of 2.5 cm or 1.0 inch at least on the bottom of the text.
We suggest that you use a text box to insert a
graphic (which is ideally a 300 dpi
resolution TIFF or EPS file with all fonts
embedded) because this method is somewhat
more stable than directly inserting a picture.
To have non-visible rules on your frame, use
the MSWord “Format” pull-down menu,
select Text Box > Colors and Lines to
choose No Fill and No Line.
Fig.1 Example of a figure caption. (figure caption)
References
[1] Eason, B. Noble, and I.N. Sneddon, “On certain integrals of Lipschitz-Hankel type
involving products of Bessel functions,” Phil. Trans. Roy. Soc. London, vol. A247, pp. 529551, April 1955. (references)
[2] J. Clerk Maxwell, A Treatise on Electricity and Magnetism, 3rd ed., vol. 2. Oxford:
Clarendon, 1892, pp.68-73.
[3] I.S. Jacobs and C.P. Bean, “Fine particles, thin films and exchange anisotropy,” in
Magnetism, vol. III, G.T. Rado and H. Suhl, Eds. New York: Academic, 1963, pp. 271-350.
[4] K. Elissa, “Title of paper if known,” unpublished.
[5] R. Nicole, “Title of paper with only first word capitalized,” J. Name Stand. Abbrev., in
press.