DOC - Hypothesis

advertisement
TITLE OF THE PAPER
C. Corresponding1, A. Author2 and B. Author2
1Affiliation
email:
address
address
corresponding author
2Affiliation
Abstract
It should be concise and short, up to 200 words. The instructions you are reading now are meant to guide you in preparing
the full paper for the Conference that will be held in Toledo (6-9 of September 2015). The full papers submission deadline is
June 15th, 2015. All submissions will be made by e-mail to conference.hypothesis2015@urjc.es
Keywords: up to 5 keywords
Paper preparation
Please use this document as the template for your paper. The accepted formats are Open Document Text and MSWord. Receipt of your paper will be confirmed by e-mail.
It is recommended that the paper is articulated in the following sections
1
Introduction
2
Materials and Methods
3
Results and Discussion
4
Conclusions
There is not page limit, but, please, refer to standard scientific papers. The file should be identified using the author´s name.
The paper must be formatted as follows. All margins should be set to 25 mm. Use a two-column format (77 mm wide each
with a 6mm separation). The recommended type face for MS-Word is “Arial Narrow” (table 1). Spanning two columns, center
the title (bold face, 14 pt) followed by the authors names (normal face, 12 pt), their affiliation, postal address and e-mail
address of the corresponding author for future correspondence (normal face, 10 pt). Underline the corresponding author.
The main text and minimum font size within all figures is Arial Narrow 10 pt. Major headings should be left-justified 12 pt bold
face, and sub-headings appear left-justified on a separate line with initial capitals in 10 pt bold face.
Illustrations and tables should not extend into the margins, and should be numbered and contain a caption. Try to avoid
vertical lines in tables.
Table 1. Example table.
Face style
Size
Title
Bold
14 pt
Abstract
Normal
10 pt
Main text
Normal
10 pt
Use a vertical space of 3 points before paragraphs. References are listed and numbered at the end of the paper and in the
text referred to by numbers in square brackets in the following manner: normal article [1] and article in proceedings [2].
________________________________________________________________________
HYdrogen POwer THeoretical and Engineering Solutions International Symposium 2015, Toledo, Spain
6 – 9 September 2015
1
Fig. 1. Example figure.
References
[1] A. Author and C. Corresponding. Title of the article. Journal Vol (year) pg–pg.
[2] B. Author. In: Name of the editors eds. Proc. Int. Conf. on Feedstock Recycling, pp. 10–16, Local, Country, 1-4 April
2002. Publisher.
________________________________________________________________________
HYdrogen POwer THeoretical and Engineering Solutions International Symposium 2015, Toledo, Spain
6 – 9 September 2015
2
Download