The Sandhurst Competition 2012 Radio Familiarization ASIP (1523E) SFC Salazar No Reference Place antenna here. Place hand mic here (either slot will work). In order to load a frequency, turn the selector switch to “LD” for load. NOTE: You will here a buzzing noise. This is the radio’s way of asking for COMSEC. Once you have changed the settings on the radio to “SC/PT” it will stop. By doing this, you have told it that it will not get any COMSEC. In order to scroll through the menu, hit “MENU/CLR” button to show the options. Once you have found the option you want, you can change the settings by hitting the “CHG” button until you find the option you need. Loading a SC/PT Frequency Use the MENU/CLR and CHG buttons to: Set CHAN to “1”. Set COMSEC setting to “PT” Set MODE to “SC”. Press the FREQ button to display [00000], then hit the MENU/CLR button, within 7 seconds, to show [_____] on the screen. Now the radio is prepared for you to enter the frequency. Now enter your frequency numbers by using the number pads (ex: 36.567). You must begin within 7 seconds or the display will go back to [00000]. After entering the frequency, hit the STO button, within 7 seconds, to store the frequency into the radio. Switch the selector switch to SQ/ON to begin transmission. NOTE: In order to send transmission, you must press the button on the hand mic to transmit, then let go once you have finished speaking to receive the distant end’s responses. TASK: LOADING SINGLE CHANNEL FREQUENCIES SUBTASKS ACTIONS a. Obtain required CUE, MAN, and SC freqs (1) Provided below b. Prepare RT for SC freq loading (1) Set COMSEC to PT (2) Set MODE to SC (3) Set FCTN to LD (4) Set CHAN to CUE, MAN, or CHAN 1-6 RESULTS N/A N/A N/A N/A RT display shows c. Load SC freqs (1) Press [FREQ] [00000] or [30000] RT display shows (2) Press [CLR] [_____] RT display shows (3) Enter 5 digit SC freqs [XXXXX] NOTE: If you make a mistake while entering a frequency press [CLR]. This action will delete the last digit entered. Press [STO] (within 7 d. Store SC freqs seconds) RT display blinks once e. Prepare to communicate (SC, PT) (1) Set FCTN to SQ ON N/A (2) Set CHAN to CUE, MAN, or CHAN 1-6 N/A (3) Communicate in SC, PT mode when desired N/A NOTE: It is important that you enter another number, or store the frequency within 7 seconds. Otherwise the display will go blank, and you will have to re-enter the number. If you require more than 7 seconds continue to press the last button, and the 7 second clock will be stopped.