Dinky Toys by Nobleco
Pullmore Transporter
Restoration
Toy number 982
• This was a parts purchase so it came looking like this or
close to.
• Another shot of all the basic parts
• Here we see the glue that was used to hold it together by
another ‘restorer’
• This is mostly stripped of paint
• A shot of the underside of all main pieces
• Here it is after going through my Glass Bead Blaster.
• From the underside. Nice and clean. Also the finish helps
with paint adhesion.
• The connector plate to join trailer to cab.
• This is a replacement part.
• Here we see the center punch marks for drilling out the
remainder of the stock rivet to allow for the new
replacement rivet. I only allow enough of the post to stick
out as is necessary to locate the top deck.
• Here you can see how little I leave for the rivet mount.
• Now we are at the rear with a center punch again.
• Hole drilled and rivets that I will use with
tops dressed.
• Primed and ready for Paint. I have a ramp for this model
too.
• First coat of paint.
• A View from the top.
• Side shot of the partial assembly of the basic parts.
• Here is another view of the painted main parts. Still
needs decks painted.
• How about some blue for those decks and hubs.
• Here she is in all her finished glory, decals applied and
with a ramp.
• From the other side with decals. Ramp too.
• Looks pretty, decked out like this.
• Final shot from the opposite side. I hope you enjoyed the
show.