Central Valley Safety Consultants Presents
Forklift Operator Training
Is Forklift Training Necessary?
 About 100
deaths each year
 About 95,000
accidents each year
 Bankruptcy
 New OSHA
training standard
Forklift Operating Goals
 Hazards and forklift stability
 Inspecting and operating a forklift
 Quiz
Authorized Operator
 Only trained and authorized personnel are
permitted to operate a forklift
 Keep unauthorized employees off of forklifts
 Keep pedestrians away from the operating
zone of a forklift
 Lock out unsafe lifts as determined in a
preoperation inspection
Operating Hazards
 Workplace hazards: ramps, railroad tracks,
slippery floors, poor lighting, congestion
 Loads: large or bulky, uneven weight, broken
pallets, poorly stacked
 Pedestrians: horseplay, unaware of forklift
areas, not paying attention
Nameplate




OSHA requires a legible nameplate
Includes modifications & attachments
Capacity
Load center
Center of Gravity
 Balance point
48”
A
 Distance from the edge of the
item to the item’s center of gravity
20”
B
40”
Load Center
 Distance from vertical face of the forks
to the load’s center of gravity
48””
A
–A: Load center = 24"
–B: Load center = 40"
80”
B
 1 inch = 100 lbs
 Important reason for keeping the load
resting against the vertical face of forks
Stability Triangle
3-point suspension
 Forklift’s center of gravity
 Combined center of gravity
 Load center beyond 24"
Combined Actions
 Center of gravity moves
side to side
 Center of gravity
moves forward
 Center of gravity moves
backward to the thin portion
of the triangle
Attachments
 Specific
operator training
 Weight of
attachments
 Increased
load center
Tipping Over




Do not jump
Hold onto the steering wheel
Brace your feet
Lean away from the fall
Forklift Operating Goals
 Hazards and forklift
stability
 Inspecting and
operating a forklift
 Quiz
Preoperation Inspection
 As an authorized operator,
it is your responsibility to
make sure your forklift
functions properly
 OSHA requires
preoperation inspections
 Company wants to comply
with OSHA and be sure
equipment is maintained
Walk Around
 Forklift properly disengaged
–Forks down, key off, neutral gear, parking brake on
 Left/right side
–Tire condition, tight lug nuts, no debris around axle,
overhead guard is solid, no debris behind the mast
 Front
–Forks in good shape, fork pins in place, backrest
solid, mast & chains greased, hoses in good shape
 Rear
–Counterbalance bolt is tight, radiator clear of debris
In the Seat
 Nonmoving checks
–Gauges, lights, horn, back-up alarm, blinking
warning light, operate the tilt & lift mechanism,
check the parking brake
 Moving checks
–Put on the seat belt, check the running brakes,
check the steering
 Look for oil or water leaks on the floor
Operating a Lift Truck




Only trained, authorized operators
Immediately report forklift-related accidents
Seat belts must always be worn
No person should stand under elevated
portion of lift truck
 Forklift controls operated only from
driver’s seat
 Never block exits or emergency equipment
 Smoking is not permitted
Loading/Unloading
 Before raising a load, understand:
–Approximate weight of the load
–Location of the load’s center of gravity
 Inspect load for stability, projections,
damaged pallets before lifting
 Restack unstable loads
 Never place weight on the back of
a lift truck to increase its capacity
 Towing always done from rear towing pin
Traveling







Always look in the direction of travel
Keep body inside the cage
When moving, the mast must not be raised
Sound the horn
Operate at safe speeds
When turning, watch rear end swing
Clearance under overhead installations
Traveling (cont.)







Avoid loose objects or holes
If load blocks view, travel in reverse
Never carry passengers
Pedestrians always have the right-of-way
Safe distance from edge of ramps or docks
Never eat or drink
No stunt driving or horseplay
Ramps and Railroads





Never turn on a ramp
On ramps the load should be upgrade
Ascend or descend ramps slowly
Railroad tracks are crossed diagonally
Never park within 8 feet of the center of
railroad tracks
Docks




Inspect the dock plate
Check the trailer floor condition
Trailer wheels are chocked
Nose of the trailer is supported
by the tractor or a fixed jack
Parking




Lower the forks
Set gear to neutral
Set the parking brake
Turn off the key
Propane Refueling
 Propane is a combustible, compressed gas
 Propane leaks are detected by:
–Distinct odor
–Hissing sound
–Frost on fittings
 PPE: gloves, safety glasses
Battery Charging




Inspect battery connectors for damage
No smoking in battery-charging area
Immediately clean up electrolyte spills
PPE includes face mask, acid-resistant
gloves, and an apron
Forklift Operating Goals
 Hazards and Forklift Stability
 Inspecting and Operating a Forklift
 Quiz
Summary





Facility hazards
Load center and capacity
Preoperation inspection
Rules of the road
Refueling
Quiz
1. If your forklift has a rearview mirror,
looking behind you is not necessary.
True or False
2. Name two of the three ways to detect
a propane leak: _______________, _______________
3. Describe the four items that must be completed
prior to driving your forklift into a trailer.
4. If a load blocks your vision, it is OK to raise
the load while moving to see under it.
True or False
5. Preoperation inspections are done only
because OSHA says we have to do them. True or False
Quiz (cont.)
6. Attachments reduce capacity by increasing
the load center and adding weight.
True or False
7. Minimum PPE items required when refueling
a propane tank are ___________, ____________.
8. The most important differences between a
forklift and a car are weight and steering.True or False
9. Name at least one condition that when
combined with turning sharply may cause a tipover.
10. Pedestrians have the right-of-way only
while in designated pedestrian lanes.
True or False
Quiz Answers
1. False. You must always look behind you before
backing up.
2. Hissing sound, distinct odor, or frost on fittings.
3. Chock the wheels, support the nose of the trailer,
inspect the dock plate, check the trailer floor.
4. False. Never drive with the load up. Drive in reverse
when the load obstructs forward vision.
5. False. Inspections are also done so that the operator
can prevent mechanical failure accidents and because
the company needs to prove compliance with OSHA’s
requirement.
Quiz Answers (cont.)
6. True. Attachments are heavy, and they cause
the load center to move away from the forklift.
7. Gloves and safety glasses are the minimum PPE
required.
8. True. There are many differences, but the most
significant are weight and steering.
9. Hitting a pothole, carrying an off-center load,
getting a flat tire, having a raised & tilted back
load, or being on a ramp.
10. False. Pedestrians always have the right of way.