Sander Instructions

advertisement
Belt Sander
Belt Tracking
If the sanding
belt starts to
move over to
the edge of
the sanding
surface, turn
the sander off
and contact
your teacher.
Belt Sander On and Off Switch
On and Off
Switch
Vacuum System
To use the belt
sander, the
vacuum system
has to be turned
on.
At the end of class
make sure the
vacuum system is
turned off.
Belt Sander Safety
When turning the
Belt Sander on and
off, make sure to
keep your hair and
clothing away
from the sanding
surface.
Jewelry can be a
big problem.
Using the Belt Sander
Correct
Always keep your work piece
flat on the sanding table.
Incorrect
The sanding belt will grab the
edge of the work piece and
pull your hand onto the
sanding surface.
Clean Up
Sweep these
areas off with
a hand broom
from the top
down. Use a
big broom to
sweep the
floor.
Disc Sander
On and Off Switch
Disc Sander
On and Off
Switch
Vacuum System
To use the Disc
sander, the vacuum
system has to be
turned on.
At the end of class
make sure the
vacuum system is
turned off.
Using the Disc Sander
The Disc
Sander turns
clockwise.
Sand on the
right side of
the sanding
surface.
Sanding Area
Using The Disc Sander
Correct
Always keep your work piece
flat on the sanding table.
Incorrect
The sanding Disc will grab the edge
of the work piece and pull your
hand onto the sanding surface
Stopping the Disc Sander
When the Disc
Sander is turned off,
the sanding disc will
keep spinning for
about 10 min.
At the end of class
the sanding Disc
needs to be stopped
for cleaning.
Use the wood from
the shelf below to
stop the sanding disc.
Push the edge of the
wood on the edge of
the sanding disc
softly to stop the
sanding disk
Cleaning the Disc Sander
Areas to clean with the hand
brooms. Clean from the top
down.
Using Sanders Video
Oscillating Sanders
On and off switches
How to sand
Correct
Always keep your work piece
flat on the sanding table.
Incorrect
The sanding Disc will grab the edge
of the work piece and pull your
hand onto the sanding surface
Using A Oscillating Sander
Keep work piece
flat on the
sanding table
The sanding tube
spins. Work in the
opposite direction
the sanding tube is
spinning
Cleaning The Oscillating Sander
Using a hand
broom to sweep
the sanding table.
The sides of the
sander. The table
the sanders are on,
and the floor
around the table.
The sawdust from
the sanders are
very fine and light.
Never blow the
sawdust.
Hand sander
Power Switch Lock
Power Switch
To keep the hand
sander running with
out holding the
power switch, hold
the power switch on
and push the power
switch lock in, then
release the power
switch
Using the Hand Sander
Sanding Surface.
Never Touch the
sanding surface
while the
sander is on
Cleaning the Hand Sander
Use a hand
broom to sweep
the table top,
the sander and
the floor under
the sander.
Sweep from the
top down.
Watch where
your head is
when
sweeping the
floor under
the sander.
Hand Sanding
When using sand
paper, make sure
to keep your
knuckle away from
the surface.
Sweep the table
top with a hand
broom
Download