PROBLEM SET 7: PHASE CHANGES AND INTERMOLECULAR FORCES
CHEM 103 (Section A02&A05 Pei) Nov. 22, 2025
References: Silberberg, “Chemistry”, 3rd Canadian ed. 11.1–11.4 Phase changes, phase diagrams, intermolecular
forces; 12.1 solubility
Similar problems in Silberberg: Chap. 11: 14, 29, 34, 37–51 odd, 61, 63, 112; Chap. 12: 9, 11, 13
1.
Vaporization and condensation.
(a) When a liquid evaporates from an open container, the temperature remains roughly constant. When the same
liquid evaporates from a thermally insulated container (e.g., a vacuum bottle), the temperature drops.
Explain.
(b) A popular chemistry demonstration, which you witnessed, involves boiling a small amount of water in a
metal can and then submerging the can in cold water. The can collapses with a loud pop. Explain why the
can is crushed.
2.
(From a previous final exam.) The Earth’s atmosphere contains N 2, O2, Ar, and variable amounts of H2O.
(a) Rank these gases in order of: (i) increasing vapour pressure, and (ii) increasing boiling point.
(b) What kind of rain falls on Earth? Is the process of rainfall endothermic or exothermic?
3.
(Silberberg, Problem 11.25) Sketch the phase diagram of ethylene (C2H4) from the following data: normal boiling
point (–103.7 C), normal melting point (–169.16 C), critical point (9.9 C, 50.5 atm), and triple point (–169.17
C, 1.20 10–3 atm). Label these points on the diagram. Is C2H4(s) more or less dense than C2H4(l)?
4.
A portion of the phase diagram for phosphorus is shown.
(a) Indicate the phases present in the regions labeled (?).
(b) Explain which is the denser, liquid or solid. If the pressure is increased, does
the melting point increase or decrease?
(c) Explain why a sample of solid red phosphorus cannot be melted by heating
in a container open to the atmosphere.
(d) Trace the phase changes that occur when the pressure on a sample is reduced
from point A to B, at constant temperature.
A
p
Solid red
P
(?)
43 atm
(?)
B
5.
590 ºC
(Silberberg, Problem 11.33) In solid I2, explain if the distance between the two I
nuclei of one I2 molecule is longer or shorter than the distance between two I nuclei of adjacent I 2 molecules.
6.
Intermolecular forces.
(a) Identify the entities (molecules, atoms, or ions) present and the dominant forces between them.
(i) CH3OH(l)
(ii) NH4Cl(s)
(iii) IBr(s)
(iv) O2(aq)
(v) graphite (C(s))
(vi) Xe(s)
(vii) KBr(aq)
(viii) NH3(l)
(b) Pick the substance that exhibits intermolecular H-bonding, and draw the H-bonded structure.
(i) (CH3)2NH or (CH3)3N
(ii) HOCH2CH2OH or FCH2CH2F
7.
Pick the substance with the specified property and justify your answer:
(a) Highest boiling point: CF4, CCl4, CBr4
(b) Lowest freezing point: LiF, Cl2, HBr
(c) Lowest vapour pressure at 25 ºC: CH3OCH3, CH3CH2OH, CH3CH2CH3
(d) Greatest viscosity: H2S, HF, H2O2
(e) Greatest heat of vaporization: H2CO, CH3CH3, CH4
(f) Smallest enthalpy of fusion: I2, CsBr, CaO
(g) Smallest surface tension: CH3OH, CH3CH3, H2C=O
T
8. Predict whether cis- and trans-1,2-dichloroethylene have the same boiling point or different boiling points. If
different, identify which form would have the higher boiling point and explain why.
(cis-1,2-dichloroethylene)
© A. Mar, Department of Chemistry, University of Alberta (2016)
(trans-1,2-dichloroethylene)
9. For which molecule in each of the following pairs would you expect greater intermolecular forces.
a. CH3CH2CH2NH2
or
H2NCH2CH2NH2
b. CH3CH3
or
H2CO
c. CH3OH
or
H2CO
d. HF
or
HBr
10. The structure of benzoic acid and benzene are shown below:
Benzoic Acid
Benzene
(a) The solubility of benzoic acid in water is 3.4 g/L but 100 g/L in benzene. Explain this difference in solubility.
(b) The solubility of benzoic acid in 1.0M NaOH (aq) is much larger than the solubility in pure water. Explain this
difference in solubility (hint: think about any reactions that may occur).
11. Identify the most important types of intermolecular forces present in the solids of each of the following substances.
(a) Teflon, CF3(CF2CF2)nCF3
(b) Polyethylene, CH3(CH2CH2)nCH3
(c) CHCl3
(d) NH3
(e) NO
(f) BF3
(g) SF4
© A. Mar, Department of Chemistry, University of Alberta (2016)