Name:
Class Title:
Period:
Date:
Band Saw Review
Directions:
1. Print out the following review
2. Complete all questions
3. Once finished with the entire review hand review into teacher.
TRUE & FALSE: Answer the following questions by writing true or false after the
question:
1. The blade guard must be placed 1/8” above your stock?
2. The band saw moves in a continuous motion, which causes your project to lift up
if not held securely to the table?
3. Continue to cut if the band saw blade begins to bend or the band saw makes
unusual noises?
4. Stock must be placed securely against the table?
5. Safety glasses must be worn at all times?
6. Cut lines should be clearly marked before cutting your stock?
7. Two hands should remain on the stock at all times?
8. Relief cuts should be marked and cut prior to cutting the finished cut lines?
9. Hands should be placed close to or on the cut line to ensure quality work?
10. Do not cut an inside radius larger than four times the blades width?
MATCHING: Complete the following questions by matching the step number to the
operation. Place the operation letter next to the number step it corresponds to.
Step Number:
1.
2.
Operation:
A. Move stock into blade following the cut
line.
B. Remove stock from band saw after
machine has come to a complete stop.
3.
4.
5.
6.
7.
8.
9.
C. Adjust blade guard 1/8” above stock.
D. Turn band saw on.
E. Move stock away from blade.
F. Make sure all guards are in place and
operating correctly.
G. Place stock flat on table.
H. Mark all cut lines.
I. Place stock against blade to adjust blade
guard.
LABELING: Label the following parts of the band saw by placing the name of the part
next to the arrow. There are eight total parts needing to be identified.
a.
b.
c.
d.
e.
f.
i.
h.